Saw video thread

[Duane(Pa)]

 

[Vintage Engine Repairs]

I'd love to run a ported Aussi 660. This is stock 25" bar 3/8 chain and in some of this dry harder wood it's fairly underwhelming. It gets the job done, but you certainly can't dog in without it bogging down.

 

[JohnnyBlade]

Husqvarna 36. Here's one i put new bearings and seals in. Muff mod. New oil pump, air filter and some smalls. Buddy wants a lil limbing saw for around the farm and I had just the saw for him. Runs great and 4 stroking good at 13,200. No need to go any higher. Good power at that rpm. About a 9" hard as a rock dead red oak limb for testing. Semi chisel 3/8" lp. 14" bar.

Russ's Husqvarna 36

This is "Russ's Husqvarna 36" by Nick Accetturo on Vimeo, the home for high quality videos and the people who love them.

vimeo.com

 

[jacktheripper]

 

[jacktheripper]

Ok, here’s another. MOFO 034 Super vs my self-ported 266xp without any machine work. Same bar and chain and same wood.

 

[huskihl]

 

[heimannm]

Play all 3 videos at once and imagine you're at a GTG.

Mark

 

[cuinrearview]

If you catch his avatar just with the corner of your eye, it kinda looks like...

 

[lehman live edge slab]

If you catch his avatar just with the corner of your eye, it kinda looks like...View attachment 466802

That’s not very nice

 

[huskihl]

If you catch his avatar just with the corner of your eye, it kinda looks like...View attachment 466802

 

[MAF143]

 

[jacktheripper]

Here’s my pretty 066

 

[jacktheripper]

Here’s another from today. 254 vs 372. I’d say that 254 pulls pretty hard! I used it for about three hours today and I love it!

 

[rogue60]

Finally got around to giving me new saw a run a ms231 it came with .325 RS.
1st tank of fuel not a bad little saw I'm impressed for a homeowner saw that's some hard Aussie Gum

 

[lehman live edge slab]

Finally got around to giving me new saw a run a ms231 it came with .325 RS.
1st tank of fuel not a bad little saw I'm impressed for a homeowner saw that's some hard Aussie Gum

Not bad at all for a 40 ish cc homeowner saw

 

[rogue60]

Not bad at all for a 40 ish cc homeowner saw

Yeah and that's out of the box not even tune it or give the chain a rub.
The exhaust outlet is tiny might open it up a bit let it breathe unleash some trapped horsies lol

 

[MustangMike]

My brother has an MS241 and loves it ... but they don't sell them anymore.

It is his only saw he will not let me modify, as he says he likes it quiet, and it cuts just fine!

 

[Partner]

Ms 250/251 cuts even better my neighbor recently ate the chain drive sprocket

 

[LAWN BOY]

Steve rebuilt the carb for me on this. Next up is my restoration.

 

[rogue60]

My brother has an MS241 and loves it ... but they don't sell them anymore.

It is his only saw he will not let me modify, as he says he likes it quiet, and it cuts just fine!

Yeah I would have got a ms241 but like ya say ya can't get em anymore.
And yeah as far as muff mods go my main goal is not increasing decibels I hate loud saws!..