Saw video thread

[davidwyby]

I probably posted this before but wanted to catch Walt. Got Big Green in there a little. Will get more content with it in a few months when we get back to double digits…have several large eucalyptus to remove. @afleetcommand

 

[davidwyby]

Added vid link I forgot.

 

[RI Chevy]

Nice job David.

 

[Red97]

562xp

 

[MustangMike]

Would be interesting to see a comparison of a ported 562 compared to a stock 462, I believe it would be close.

With the newer 6 bolt case, powerhead weight should also be similar.

 

[Ronie]

372 with a 371k case with a crappy Hippa chain that won't hold an edge.

 

[Slumberjack]

372 with a 371k case with a crappy Hippa chain that won't hold an edge.

Well the saw sure sounds good

 

[Crocky28]

372 with a 371k case with a crappy Hippa chain that won't hold an edge.

That’s a sexy 372!


Sent from my iPhone using Tapatalk

 

[Ronie]

Well the saw sure sounds good

That’s a sexy 372!

Thanks, that was the fourth cookie I had cut with it since sharpening and it had about had it. It was free chain, so I guess I shouldn't be complaining.

 

[RI Chevy]

Nice Ronie.

 

[Ronie]

Nice Ronie.

Thank you

 

[Red97]

Oe372 n stuffs

 

[Red97]

500i

 

[farminkarman]

500i

Joe, just curious, how is the throttle response on the 500 with the intake port that low?

 

[Red97]

Joe, just curious, how is the throttle response on the 500 with the intake port that low?

They are still pretty snappy

 

[TreeLife]

They are still pretty snappy

I think it being fuel injected and being able to tune lean tip in on these and mtronic/AT saws makes them snappy. Sure they can be made snappier with some epoxy, but is it really worth it?

 

[davidwyby]

Welp, it runs. Semi chisel safety chain I ran thru my grinder but could probably use more hook and less raker…

might be good for sailing

 

[davidwyby]

 

[Crocky28]

550xp mark II


Sent from my iPhone using Tapatalk

 

[Crocky28]

Nice clean MS440. Liking this saw.


Sent from my iPhone using Tapatalk