Saw video thread

[Nutball]

This is what we've all been waiting for

 

[kingOFgEEEks]

This is what we've all been waiting for

 

[Wolverine]

This is what we've all been waiting for

That sir, is awesome!

 

[Fruecrue]

This is what we've all been waiting for

@RI Chevy
Make him an offer he can’t refuse.

 

[Fruecrue]

This is what we've all been waiting for

@RI Chevy
Make him an offer he can’t refuse.

 

[Fruecrue]

Whoa, triple poasty.
How da fuq?

 

[RI Chevy]

I'm gettin double vision.

 

[huskihl]

@jacob j.

 

[jacob j.]

@jacob j.

Holey Schnickeys!

 

[AlfA01]

@jacob j.

Kev, if you keep cranking wood swords like that out you're gonna have to change your sig to say "backlogged through next December".

 

[RI Chevy]

Very nice Kevin. [emoji106]

 

[huskihl]

Thanks guys.
Normally I don't get so far backed up. But with my gtg a few weeks ago, helping with my son's wedding reception venue, and my regular job, I needed a break. Another few months though and it'll be sunny and 70 in the shop

 

[chipper1]

Whoa, triple poasty.
How da fuq?

The saw that broke the net.

 

[Dub11]

Holey Schnickeys!

I was thinking the same thing when he gave us that sweet ass shot.

 

[huskihl]

Leave it to Wayne.
Back to clutch-side videos for yuse guys

 

[Dub11]

Leave it to Wayne.
Back to clutch-side videos for yuse guys

Just switch hands.

 

[chipper1]

Leave it to Wayne.
Back to clutch-side videos for yuse guys

Thanks!

 

[00wyk]

This thing is a little crazy, but if I were to show you the cylinder, which of course I can't find the pic of now, you would be amazed how it runs like this. I barely massaged the bottom transfers and exhaust at all. This is a gasket delete, and all uppers and intake here, with three holes in the muffler. It's cold weather out and race saw lean for the vid, tho.
22" bar(78dl), stock chain, green beech - HyWay 76cc top end. The wet AF Beech had a bit of a pinch in it, so I was careful towards the end of the cut - it was downed in a storm and I had just cut off the root ball.

Love that idle sound. I'm swearing at the top of the vid because I couldn't start it with my left hand.
ETA, I also am purdy sure I advanced the timing, too.

 

[RI Chevy]

Nice!

 

[00wyk]

For comparison, here's an open port 65cc OEM top end in the exact same wood zoomed out a bit. BTW, both saws wearing 8pin rims. Well, both builds - same saw. SInce that 76cc top end just looked like a normal ported top end, I don't think I bothered taking pics. Especially since I didn't think it would run like it did. But I DO have pics of this ported OEM 65cc top end since it was a bit out of the ordinary. If I had it to do again, I would have sculpted the bottom end tighter to increase flow.

And this is what it looks like stock(courtesy of MKinslow):