Saw video thread

[Redbull661]

re-testing my paint on and off theory on bar tip

 

[Frank bierce]

re-testing my paint on and off theory on bar tip

32" oregon lite with factory black paint finish on tip. Tip readings 153-163F cut time 40.3

removed the black paint off tip - Tip readings drop to 90-118F. cut time 40.9 Cut time didn't improve as I was now out of the checking/ends of the boards.

Wow,, that is quite the difference!!

 

[Deets066]

I said I'd get a video with the hybrid and a 36....... Well, we'll have to settle for 32" with a 9 pin

 

[Toad22t]

I said I'd get a video with the hybrid and a 36....... Well, we'll have to settle for 32" with a 9 pin

View attachment 33240

See this right here makes me want to build a hybrid again. I should just stop watching these thread's.

 

[Deets066]

See this right here makes me want to build a hybrid again. I should just stop watching these thread's.

The first hybrid I built ran good.... I tried to make it better but only made a turd. So I got a new cylinder which turned out to be a good one.

I'm pretty happy with the results

 

[mdavlee]

I just wish they weren't so high strung.

 

[Toad22t]

The first hybrid I built ran good.... I tried to make it better but only made a turd. So I got a new cylinder which turned out to be a good one.

I'm pretty happy with the results

I kept my last 046 d chamber cylinder just in case I came across another 12mm 044. Maybe for a rainy day project.

 

[Chainsaw Jim]

The first hybrid I built ran good.... I tried to make it better but only made a turd. So I got a new cylinder which turned out to be a good one.

I'm pretty happy with the results

What did you do with the turd cylinder?

 

[Deets066]

I just wish they weren't so high strung.

This one is way more high strung than the first cylinder I built. It could handle 16,000 for a cant race. But I feel pretty comfortable at 15,200 for most stuff. That what it's tuned to in the vid

 

[Deets066]

What did you do with the turd cylinder?

It wasn't terrible, better than stock but not by much. It ran better on a 46 case, so it went on the 46 I donated

 

[JT78]

So here is my 359 first saw I ever ported and also first saw I ever purchased.

 

[JT78]

Stock 041 I cleaned up a few years back.

 

[JT78]

041 that was a DOA I was given it has a new set of bearings,seals,carb kit, opened the muffler and widened the intake and exhaust, also base gasket delete.

 

[JT78]

This one is a 923 xl this has been my biggest headache saw every time I get it running something else either breaks or goes wrong. It sheared the flywheel key at the end of this video.

 

[mdavlee]

 

[mdavlee]

Completely stock 56cc Efco

 

[mdavlee]

JMS ported 346

 

[mdavlee]

 

[mdavlee]

Best running saw I have right now.

 

[MustangMike]

Best running saw I have right now.

An 064???