Saw video thread

[dall]

whos ron

 

[Definitive Dave]

Ron is actually Thor the Norse God of Thunder, he descends from Asgard to thrash mere mortals.
He is actually a great guy but not on forums. His 088 left me dumbfounded the first time I saw him run it up North.

 

[Chainsaw Jim]

Here's the first few cuts with this 024 build. I need more wood!

 

[jmssaws]

 

[Duane(Pa)]

 

[t4driller]

An 044 is close....

I was actually using my hybrid at the same time cutting that tree up. Made a couple cuts with it and shut it off and grabbed the hooskie. That little thing is just fun to run.

Sent from my SM-G930V using Tapatalk

 

[mdavlee]

Ron is actually Thor the Norse God of Thunder, he descends from Asgard to thrash mere mortals.
He is actually a great guy but not on forums. His 088 left me dumbfounded the first time I saw him run it up North.

Ron is a good guy.

 

[Wolverine]

Good to see ya postin' vids Mike. Tree four six seems snorty!

 

[huskihl]

Stihl vs Husqvarna: the primal conflict - it doesn't get any closer than this

Yeah, but.....


That 026 is just different. It's pretty easy to get good gains from a 346. Making an 026 run with that saw is voodoo. It even sounded bigger than it was

 

[t4driller]

Good to see ya postin' vids Mike. Tree four six seems snorty!

Thanks J, wish I could keep it. Guess I'll have to build myself one someday. I'm looking forward to building myself that 357xpeee

Sent from my SM-G930V using Tapatalk

 

[X 66 stang347 X]

Now this is the 372 I remember. Played around with this 372 some more. Got a new grind on 372 chain. Made a huge difference. Not that far behind ported 394, this was in same log. 20" 8 pin dead oak. 044 look out.

Nice running saw. You bump the timing up? Tune sounds good.

 

[Deets066]

044 look out

 

[Armbru84]

Good transfers deets.

 

[Deets066]

Good transfers deets.

I seem to do better with a heavier saw

 

[huskihl]

I seem to do better with a heavier saw

So let's see the 090 with a 20" then. You should be seamless with that rig lol

 

[Deets066]

So let's see the 090 with a 20" then. You should be seamless with that rig lol

If I had a spare 66 mm jug layin around, I'd grind her up and try it

 

[mdavlee]

If I had a spare 66 mm jug layin around, I'd grind her up and try it

Be a cheap one to experiment on and then plate. http://www.ebay.com/itm/201660109376

 

[malk315]

Now this is the 372 I remember. Played around with this 372 some more. Got a new grind on 372 chain. Made a huge difference. Not that far behind ported 394, this was in same log. 20" 8 pin dead oak. 044 look out.

Definitely in the saw's powerband putting torque to work.

Sent from my XT1585 using Tapatalk

 

[Deets066]

Be a cheap one to experiment on and then plate. http://www.ebay.com/itm/201660109376

 

[huskyboy]

Nice running saw. You bump the timing up? Tune sounds good.

Just a much better chain and repaired the leaking gas tank seam with a solder iron.