Saw video thread

[paragonbuilder]

He waved his magic wand over it and said "Hocus Pocus."

Lol!
I've got one to mess with, just curious what his thoughts were.

 

[Chainsaw Jim]

What did you do to her?

What did you do to her Jim?

Simple port work, base gasket delete, squish band cut, muffler mod, and timing bump.

 

[Cigmaker]

Simple port work, base gasket delete, squish band cut, muffler mod, and timing bump.

Simple huh. Then why can't I do it lol

 

[Chainsaw Jim]

Here's an 034av I ported that's been put to use by a tree service full time for just over a year now. It needed a little maintenance so I got my hands on it again for a video.
It showed up pho so I put that set up on it to see it cut. It normally wears a 25" bar.

 

[dall]

played with my mmws 361 and square ground chain

 

[RI Chevy]

Here's an 034av I ported that's been put to use by a tree service full time for just over a year now. It needed a little maintenance so I got my hands on it again for a video.
It showed up pho so I put that set up on it to see it cut. It normally wears a 25" bar.

Jim, do you think dropping to an 8 pin would keep the RPM'S a little bit higher and in the sweet spot? Sounded like it was a little low on the RPM'S in the cut when dogged. 8 pin may "work" a little better.

 

[RI Chevy]

Sounded good Dallas. Chain and saw were really cutting well.
Is that Mtronic?

 

[dall]

no thats my mmws 361 randy did for me last summer

 

[RI Chevy]

Nice. Held RPM'S well in the cut. [emoji106]
You compare the square filed chain to a round filed chain in the same wood?

 

[dall]

Nice. Held RPM'S well in the cut. [emoji106]
You compare the square filed chain to a round filed chain in the same wood?

no i didnt im slacking lol

 

[RI Chevy]

Come on Dallas. Lol
No slacking allowed.
One must always cut with a purpose. For the good of the order. Lol

 

[jmssaws]

Lol!
I've got one to mess with, just curious what his thoughts were.

I got a brand new one to port and I've never even ran one much less port one.
There stupid expensive is all I know about one.

 

[sawmikaze]

Jim, do you think dropping to an 8 pin would keep the RPM'S a little bit higher and in the sweet spot? Sounded like it was a little low on the RPM'S in the cut when dogged. 8 pin may "work" a little better.

They dont make a .325x8 in the larger spline...i wish they did.

Only oregon small and stihl mini.

 

[Magnumitis]

They dont make a .325x8 in the larger spline...i wish they did.

Only oregon small and stihl mini.

Unless I'm thinking different sizes, they do. I had my hands on one a little while ago.

 

[RI Chevy]

I think I just bought a .325 8 pin. I have to check. It may have been 3/8 8 pin.

 

[Magnumitis]

Unless I'm thinking different sizes, they do. I had my hands on one a little while ago.

I was wrong. It's a small spline.

 

[dall]

i just bought a bunch of 325 by 8 and 3/8 by 8

 

[dall]

 

[Magnumitis]

Those .325 are small spline compared to the 3/8.

 

[dall]

right 325 are small splined