Saw video thread

[huskihl]

Looks good Kev, that’s a gnarly piece of wood.

what numbers did you end up with?

Red oak crotch. Not real soft
The cylinder had decent numbers I thought. Stock no gasket 99-121-78. I ended up 100-120-81

 

[ayoungtexan]

Oiler on the 395 is definitely more sufficient for longer bars, side adjust on the 066 is sweet though.

The 66 is a bit lighter and easier to use, but from my experience it just doesn’t have the grunt of the 395. If they were ported, that could be a different story

 

[huskihl]

What were the numbers Kev? Decomp? Looks really good by the way

Decomp, yes. Numbers^

 

[markds2]

Decomp, yes. Numbers^

Sorry, I didn't see Deets post before I posted. Did you have to epoxy the intake at all?

 

[huskihl]

Sorry, I didn't see Deets post before I posted. Did you have to epoxy the intake at all?

This is the first 066/660 cylinder I’ve done that didn’t end up at 83-84 after machine work. No epoxy

 

[Deets066]

Red oak crotch. Not real soft
The cylinder had decent numbers I thought. Stock no gasket 99-121-78. I ended up 100-120-81

Pretty dang good numbers, takes a lot of grinding out of it when they are close to start with.

 

[huskihl]

@StuntCockWelder

 

[Rogee]

Oiler on the 395 is definitely more sufficient for longer bars, side adjust on the 066 is sweet though.

Yes and I do prefer the inboard clutch if things get jamed up

 

[Deets066]

@StuntCockWelder

Saw looks stout Kev.

Chain looks dull though, might need a touch up.

 

[huskihl]

Saw looks stout Kev.

Chain looks dull though, might need a touch up.

Lol. Yeah right.
I tried boring with it. No bueno

 

[Deets066]

Lol. Yeah right.
I tried boring with it. No bueno

Careful.... you might kink a sausage

 

[huskihl]

Careful.... you might kink a sausage

That hasn’t happened in 30 years. But I’ll keep it in mind just the same

 

[Canadian farm boy]

Fresh off the bench. Only about 1/2 tank of fuel on a new top end and port job.

 

[dustinwilt68]

Damn fine job on the 572 Mike! Strong.

 

[RI Chevy]

Awesome Mike!!!
Held some nice rpms in the cut!

 

[huskyboy]

Baby saws.

 

[huskyboy]

Big saws.

The 390xp was ported by someone else. I don’t know anything about it other than I tuned it and ran it.

 

[malk315]

Holy *s-word Mike!

Sent from my Pixel 3 using Tapatalk

 

[ranchdadmike]

Fresh off the bench. Only about 1/2 tank of fuel on a new top end and port job.

That’s a fine saw!

 

[RI Chevy]

Big saws.

The 390xp was ported by someone else. I don’t know anything about it other than I tuned it and ran it.

I'd take that 064/66 all day over the Hooskie 390. Nice saw.