Saw video thread

[redlight066]

Did you mod the oiler for milling? Those saws are pretty poor oil output stock with the standard pump.

Thanks for reminding me. I noticed it when I was loading up the saw. Chain was on the dry side, not dusty tho. Forgot all about it while reading 20+ pages of a hot topic today.....

 

[huskyboy]

Thanks for reminding me. I noticed it when I was loading up the saw. Chain was on the dry side, not dusty tho. Forgot all about it while reading 20+ pages of a hot topic today.....

If anything you made it run better with the increased BTU’s from the hotter chain lol

 

[PA Dan]

If anything you made it run better with the increased BTU’s from the hotter chain lol

He gets it...!

 

[redlight066]

I may tear it back down and add a velocity port. that will increase the compression in the muffler pipe and that will raise my btu's to one jigga-watt and i can finally get to 88MPH in the cut.

 

[ferris]

That saw has the standard port job?
Or even stock?

 

[redlight066]

What are your #s, if you don't mind me asking. I like to try to keep track of this stuff somewhat.

I have seen low (numerically high) upper transfer #s work well on many jugs, I think it improves velocity, but what do I know?

80/121/101

 

[MustangMike]

I have an Asian 660 (w/Cross P+C) that was ported (w/machine work and bridge ports). #s were 100, 120, 80. It ran good, but not great.

I raised the Ex a bit, and lowered the Intake a bit and shaped the ports a bit flatter and the saw runs like a beast. I also gave it .030 timing advance (from .020). That saw will noodle large hardwood rounds with ease!

Went through these White Oak rounds like they were butter.

 

[PA Dan]

Finally got the new to me Dolmar 5100S back together! I gutted the muffler and rebuilt the carb. She's running a 20 3/8" bar and Stihl RS chain.

 

[TreeLife]

Finally got the new to me Dolmar 5100S back together! I gutted the muffler and rebuilt the carb. She's running a 20 3/8" bar and Stihl RS chain.

5100 is a mighty little saw!

 

[RI Chevy]

Nice job Dan.

 

[huskyboy]

 

[Mkinslow]

Is that a closed or open port bud?

Sent from my SM-G892A using Tapatalk

 

[PA Dan]

Who did the porting Mason?

 

[huskyboy]

Same saw in hardwood. Dead ash sure makes a lot of dust as you can see. Lol

 

[huskyboy]

Is that a closed or open port bud?

Sent from my SM-G892A using Tapatalk

Closed port

Who did the porting Mason?

I did, no machine work just basic woods port with popup piston.

 

[PA Dan]

That's awesome Mason looks like it's running good! What's your thoughts?

 

[RI Chevy]

He's going full out to beat a 59cc Stihl. [emoji16][emoji2957][emoji482]

 

[huskyboy]

That's awesome Mason looks like it's running good! What's your thoughts?

It’s not broken in yet, but it feels good so far. It’s got a lot of torque for 65cc. Wide powerband.

 

[huskyboy]

He's going full out to beat a 59cc Stihl. [emoji16][emoji2957][emoji482]

Nuffin’ is unbeatable lol

 

[HYPERSAWS]

How you like that cannon