Saw builds

[jmssaws]

Spray any of them and it will be very obvious where it's leaking

 

[junkman]

Did you check the metal flange between the carb and boot ,they are common to crack there .

 

[jmssaws]

Did you check the metal flange between the carb and boot ,they are common to crack there .

It is the other style that doesn't use the plate.

 

[junkman]

I forgot to put this after my quote

 

[Mattyo]

Run it....or toss this brandy new cylinder?

Was doing the transfers and it just kept flaking

 

[Mattyo]

Here's the 394

 

[jmssaws]

I've had lots of ks cylinders chip grinding with a double cut burr so I only use single cut or if it don't need a bunch of material moved a stone will not chip.

What kind of burr are you using.

 

[Mattyo]

It's a cross cut carbide....dental drill

 

[jmssaws]

Try a single cut with heavy pressure or a stone.

 

[Mattyo]

I have polishers too that I use for finish up....but good point on the stone ...I'll hit it with a stone later....at the office now

 

[Mattyo]

I may go back to diamond. I don't know if single cut burrs exist in this particular size.

 

[Mattyo]

Would u run it? Or should I toss at this point?

Haven't done the rest of the port work....don't want to do it if it's junk

 

[jmssaws]

I can't really tell from the pic.

 

[jmssaws]

Looks like a problem to me,what cylinder is it? 372?

 

[jmssaws]

Anybody have any experience or thoughts on this

 

[junkman]

Racers do that for cookie cuts ,bad for a working saw ,i would add weight on a work saw .

I like the flush mount pull handle ,cleans up the look of the left side .

 

[Mattyo]

Hyway 45mm ....for my 350

 

[jmssaws]

Racers do that for cookie cuts ,bad for a working saw ,i would add weight on a work saw .

I like the flush mount pull handle ,cleans up the look of the left side .

I've not noticed any loss in cut power from a light flywheel,usually just gains buy I've never tried one this light.
It was a broke flywheel so I done that,useless the way it was.

I hate the handle in a husky, always in the way tuning so I cut the damn thing off shorter

 

[junkman]

I've not noticed any loss in cut power from a light flywheel,usually just gains buy I've never tried one this light.
It was a broke flywheel so I done that,useless the way it was.

I hate the handle in a husky, always in the way tuning so I cut the damn thing off shorter

It may run hotter without the extra cooling fins ,i only run longer bars so what i like in a saw is different than a lot of the rh coast likes .
Kind of like putting a cr250 flywheel and ignition in a 250r quad ,it will rev quicker ,but break the tires loose easier but loosing tourque for tire hook up ,a saw chain has to hook up in softwoods to cut fast ,maybe opposite of the hardwoods in the east ?

 

[jmssaws]

It's not for a work saw.
I should have clarified, my bad.

Just for play time nothing else