Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube"

[Ketchup]

You will probably have to cut the corner off the top few fins where the plug wire goes.

 

[upstateamish]

You will probably have to cut the corner off the top few fins where the plug wire goes.

hmm, possibly I did test fit it earlier when I was messing around with the top and the wiring appeared to not get pinched (but I'll double check)


Tonight has taken longer than expected as I've spent it modifying parts/messing around to get things working with the intake...

After building some custom parts for the last round I had ordered all the correct things for this one... (e.g. the 390 intake boot and bolts, a farmertec metal throttle cable holder, etc) but reviewing my notes / orders it appears they were out of stock and I was refunded ... and I got side tracked and never ordered the parts again.

So, I was able to use a 372 boot. (but because it needs to be an angle I trimmed where the impulse line would go (which is fine as it now comes through the floor plate) And digging through my parts I found some bolts which were the correct length (but a larger diameter) so maybe from a 285, anyway I drilled the x-torq filter holder and tapped my metal throttle cable holder to match / fit...

And now I've got the 395 carb in place (Oh, I also modified the carb's choke lever opening so the x-torq choke lever will fit)





Now to get everything glued down / more things put together

 

[upstateamish]

You will probably have to cut the corner off the top few fins where the plug wire goes.

you're correct I modified the corner so theres no wire rub


Muffler bolts up without issue (I'll be adding the addtional opening on this like the other saw)


and I have to trim the chain brake handle to clear the top cover but it's starting to look like a saw





if I get those last couple things done I may try and fire it up this afternoon and see if all the work I've done (e.g. crankrod, piston, etc) blows up in catastrophic fasion

 

[Ketchup]

You will probably have to cut the corner off the top few fins where the plug wire goes.

There’s an existing problem where the plug wire wears against the top cylinder fin. That’s why the top cover has that little snap-in space. But with the higher jug the cylinder rubs the wire even clipped in the cover. You can squish it all together, but it will chew the wire up pretty quickly.

Edit: Haha. You’re one step ahead of me. Looking good!

 

[Rich Fife]

I'm Loving this Build. Great Job man!!!

 

[upstateamish]

There’s an existing problem where the plug wire wears against the top cylinder fin. That’s why the top cover has that little snap-in space. But with the higher jug the cylinder rubs the wire even clipped in the cover. You can squish it all together, but it will chew the wire up pretty quickly.

Edit: Haha. You’re one step ahead of me. Looking good!

Yup I did clearance the top cover in this area, but as you note the higher jug means that the wiring gets pulled and could be pinched (I noticed that it's tight on my prior build so I'll have go back and check / clearance that one as well)

I'm Loving this Build. Great Job man!!!

Thanks! I know there are areas I can improve and will make those adjustments on the next itteration. I appreciate everyone's input/insight as I move through the builds!