How do you get this....

[trooney]

Freakin air filter holder off this carb on a 271. ALL my sockets, t handles, and nut drivers are to big for the recess. Does the Stihl 8mm t handle socket wrench do it? I hate these fuki* new clamshells, or clamshells period. Thanks.

 

[jacktheripper]

My snap on 8mm was the only one that would fit out of about 6 that I tried

 

[hacskaroly]

Does the Stihl 8mm t handle socket wrench do it?

Yes, it is an 8 mm socket - skinny socket. I got one for about $10, ends up working great on a lot of saws with 8 mm nuts.

 

[Canadian farm boy]

Get a cheap 8mm or 5/16 deep 1/4 drive socket. Chuck the socket up in a drill and turn it down on a bench grinder. Just go slow with light pressure. I’ve done this to countless sockets when I needed a thinner sidewall.

 

[Woodwackr]

Get a cheap 8mm or 5/16 deep 1/4 drive socket. Chuck the socket up in a drill and turn it down on a bench grinder. Just go slow with light pressure. I’ve done this to countless sockets when I needed a thinner sidewall.

Exactly what I did

 

[jacob j.]

Get a cheap 8mm or 5/16 deep 1/4 drive socket. Chuck the socket up in a drill and turn it down on a bench grinder. Just go slow with light pressure. I’ve done this to countless sockets when I needed a thinner sidewall.

Exactly what I did

Me too - I had to make a couple for the MS-241s.

 

[Outback]

And also me. I put the socket on the end of an extension when I was close to done to kind of even out the grind, but other than that the same.

 

[ZERO]

Darn, so much good advice here, something new for me.

Now I know why they told me a long time ago, never part away with your old beat up sockets.

 

[Rich Fife]

I turned a few sockets in the lathe.