how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread?

[WKEND LUMBERJAK]

Or they could just leave it alone!!!


Sent from Hoskvarna Hills

REPPED.

 

[67L36Driver]

We even salvaged the crankcase screws.

 

[Hedgerow]

Bay 2 is ready to start dumping into.

 

[BrettL]

Need any other oly parts? I think I have a few...
heard anything from tbone75? Aka John


Sent from my iPhone using Tapatalk

Hi Jacob. Concerning oly parts, do you have Any 999f parts?

 

[WKEND LUMBERJAK]

This time change is a conspiracy.

 

[Dub11]

This time change is a conspiracy.

It is and it needs to stop!!

Morning Kenneth

 

[cobey]

Morning all

 

[Workshop]

Morning everybody.

 

[Dub11]

Morning all its windy here today

 

[hoskvarna]

About 4in in the alps so far.

Morning all


Sent from Hoskvarna Hills

 

[WKEND LUMBERJAK]

This weather would have made more sense in February.

 

[jeepsnchainsaws]

Snow! AGAIN!
Good morning local saw friends!

 

[SteveSS]

Morning folks. Kind of a crappy day out there. Just enough moisture falling to make a mess, but not enough to amount to any precipitation.

 

[67L36Driver]

Morning midlanders!

 

[sunfish]

Inside the shop day today. With wood heat!

 

[BrettL]

Good afternoon y'all.

I thought I had a good MS192TC but its only 120psi. Runs and cuts decent but I can tell its on the brink of being a non runner. NWP has an engine for $120 but I've got $100 in it already. I'm going to put a new piston and rings in and see what they do for the compression.

 

[67L36Driver]

Pulled the jug off the 012. Piston/rings/cylinder look great!
Now why has it only 100psi and won't pull a load?[emoji21]

 

[Workshop]

What's the end gap on the rings, Carl?

 

[BrettL]

I guess 120 psi warm was ok on my MS192TC. I tuned the carb a bit and its cutting strong through 4" seasoned hedge. I know that would be child's play for my 200t, but I'm satisfied on the 192.

 

[BrettL]

Any Jonsered guys close to Wichita? There's a Turbo 2050 at AOK Pawn on Broadway marked 129. Its been there for a while and they're taking 30% the saws like that. Its definitely been used but it looks taken care of. I haven't inspected it close though.