how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread?

[jeepsnchainsaws]

What?????
U buy that???

Hell no!
I was out at $300. I have seen them go for $500 most of the time, but $650 for that one looked about right... It is nice!

 

[sawnami]

Found a belt for him in the Homie parts pile you did.

Cobey had to help me carry that at Matt's GTG.
Too much for this geezer.
Sounds good!

Yeah, it is heavy for sure.

Sent from my SM-T900 using Tapatalk

 

[Ethan Hamby]

Stihl didn't open up for the dealer to order parts I just checked. So Thursday is the earliest my saw will be running

 

[Hinerman]

Hey, at least you didn't crash anything because of it..
And no casts, or hospital trips..

Lol

Amen to that...

 

[Workshop]

Need to have a film crew follow Thomas around.
The mouse episode would have been priceless.

 

[ramrat]

Is anyone interested in a very clean Homelite 360 starting to clean out garage. Will start of carb cleaner.

 

[Homelite410]

Is anyone interested in a very clean Homelite 360 starting to clean out garage. Will start of carb cleaner.

Cobey Cobey Cobey

 

[67L36Driver]

Cobey Cobey Cobey

Yes. Is worth saving for the ignition parts.[emoji849]

 

[cobey]

Is anyone interested in a very clean Homelite 360 starting to clean out garage. Will start of carb cleaner.

Yep love them ....

 

[cobey]

Is anyone interested in a very clean Homelite 360 starting to clean out garage. Will start of carb cleaner.

Pm sent

 

[jeepsnchainsaws]

Is anyone interested in a very clean Homelite 360 starting to clean out garage. Will start of carb cleaner.

ME ME ME !!!

 

[jeepsnchainsaws]

Pm sent

NM, I'm out. Got excited, lol

 

[67L36Driver]

Since it's the last day of 2016 I decided to clean out my phone and start over.

Downloaded all the pictures . Reduced the load to just below 600 from almost 900. [emoji15]

Deleted all the messages except last seven days.

Now getting rid of duplicates and triplicates off the 'puter for the past two hours.[emoji21]

 

[67L36Driver]

I did find some really funny chit for posting later.
[emoji48]

 

[Ethan Hamby]

My ms310 is getting 10,600 in the cut but that's with a stupid 16" bar I need to throw the 24" on it... That's what I like best on it

 

[Ethan Hamby]

All my bits are in those SE-51NF are ridiculously expensive

 

[ramrat]

Pm sent

You got the first shot.

 

[Homelite410]

Had a first today... Working on a super 2[emoji35] it would idle and open the throttle and it did nothing.... Puked fuel out but no speed up.....



No filter or cover..... Stick was jamming up the reed.. Now it needs the driver dip!

 

[67L36Driver]

You pulled it out of the housing, right Michael?

Then, just dunk it in a bucket.

Takes a certain 'tip and slide' to get it back in.

 

[Ethan Hamby]

I got the wrong bits for beveling port edges and you guys didn't tell me wtf haha