DD's 064 hybrid #2

[Definitive Dave]

I sent Jason a piston pin bearing that couldn't handle the job.
It probably made matters worse that I gave it a cold piss revving.
Saw is fine with a new piston and I learned my lesson

 

[paragonbuilder]

I sent Jason a piston pin bearing that couldn't handle the job.
It probably made matters worse that I gave it a cold piss revving.
Saw is fine with a new piston and I learned my lesson

Aftermarket no good Dave?

 

[Definitive Dave]

Not in this case I am a damn fool for thinking it would be.
It turned the wrist pin bearing to powder

 

[paragonbuilder]

Not in this case I am a damn fool for thinking it would be.
It turned the wrist pin bearing to powder

That is good to know! Musta been me pulling hard on the dogs! Oh wait there were none[emoji23]

 

[jmssaws]

 

[jmssaws]

 

[jmssaws]

Wish my 064 was here to compare to, there close.

Gonna try the 50" on it

 

[Definitive Dave]

Oh yeah!!!
Damn I love an 064.
Straight up or hybrid just a flat out beast!

 

[paragonbuilder]

Not in this case I am a damn fool for thinking it would be.
It turned the wrist pin bearing to powder

How long did this saw last on the aftermarket bearing Dave? You haven't had it that long have you?

 

[jmssaws]

How long did this saw last on the aftermarket bearing Dave? You haven't had it that long have you?

It didn't take long.
Thankfully the cylinder is fine,it's a very good one

 

[jmssaws]

Oh yeah!!!
Damn I love an 064.
Straight up or hybrid just a flat out beast!

Not only are they great saws there also fantastic in the sack!

 

[MustangMike]

I think two cuts by Bret and one by you!!!

The saw looks great now! The cylinder was OK???

 

[paragonbuilder]

It didn't take long.
Thankfully the cylinder is fine,it's a very good one

That's crazy. Dave you need to tell your sources...

 

[jmssaws]

 

[jmssaws]

 

[jmssaws]

I said it was a any bar saw so I tried several.

 

[Definitive Dave]

The saw had tanks of fuel through it.
Farmertec bearing because I was out of oem
I don't actually sell the ft bearing but have some in a box

 

[MustangMike]

All the same pin?

 

[hseII]

I always have my eye open for these cylinders.

Don't really see many. I like them better than 99% of the old cylinders.

Do you have an approximate time frame when these better cylinders started showing up?

 

[Brewz]

I would love to see how one of those goes in the timber in Australia.

Wink wink

Are the old 066 red light short cases the same as the 064 case?