Chain changing tension as it rotates

[Woodtroll]

The crank did not get bent and then unbend itself and then bent again. So don't worry about that.

And the crank is not changing position while you're advancing the chain by hand. The clutch drum should be spinning freely while the crank stays stationary. I don't believe the crank is bent, either, but I'm definitely curious to see what you figure out.

 

[STOVE]

The crank did not get bent and then unbend itself and then bent again. So don't worry about that.

So it’s down to, Oregon versa lightweight bar or the tensioner.

The 28” added too many variables, so I’m wondering if I add the OEM 325 sprocket back and it’s gone. That lays it on Oregon bar alone?

 

[Duane(Pa)]

Observe the protrusion of the nose sprocket teeth as you rotate it. This is dragging on like it's winter or something! lol

 

[Outback]

The tensioner isn't doing anything after you tighten the bar nuts. Forget about that.

You have a wierdly stretched chain, Which I believe you said you eliminated as a problem. I did not reread the thread.

Or a bad drum, rim, drum bearing or bar tip sprocket. Check all of them for play,