Wanab
Super OPE Member
Opportunity rears it's ugly head again. Sorry for the delay but life happens.
Our next competitor is the Farmertec, Huztl. We have a very nice example that seems typical of current offerings. The port finish seems to be average. . That is to say good but not the best ever. The plating has proven to be extremely durable. It's seems to me the jug is modeled after the redlight saws. Timing comes in at 119/98/82. Clearance is heavy at .028.
The bore itself is flawless after run-in with a well defined cross hatch. Anything you see in the photos is reflection and not imperfections. I was not concerned about a better photo because again it is flawless.
The way this runs is typical of what others have found. If makes for a very satisfying cutting experience. Both the cylinder and piston are usable in stock form with this example. Power wise it is very close to the Cross jug. I will say it has a bit less bottom power. I would have no worries swinging this saw just as is.
Our next competitor is the Farmertec, Huztl. We have a very nice example that seems typical of current offerings. The port finish seems to be average. . That is to say good but not the best ever. The plating has proven to be extremely durable. It's seems to me the jug is modeled after the redlight saws. Timing comes in at 119/98/82. Clearance is heavy at .028.
The bore itself is flawless after run-in with a well defined cross hatch. Anything you see in the photos is reflection and not imperfections. I was not concerned about a better photo because again it is flawless.
The way this runs is typical of what others have found. If makes for a very satisfying cutting experience. Both the cylinder and piston are usable in stock form with this example. Power wise it is very close to the Cross jug. I will say it has a bit less bottom power. I would have no worries swinging this saw just as is.
Last edited:
