Any Cylinder Testers Here?

[Gentleman]

I have a 2 pcs each of nikasil cylinder samples for MS260, MS360, MS290. Who wants to test? You have to make a thread and report back.

 

[Definitive Dave]

@drf256
@Jughead

 

[awol]

I could do a 260.......

 

[Four Paws]

I could do a 3120xp

 

[Jughead]

i can test either a 260 or 360.only have one 036/360 to build but have a stock 026 and another to build to compare to witj one of those kits.
will be placing an order too.either tonight or tomorrow.

 

[Gentleman]

i can test either a 260 or 360.only have one 036/360 to build but have a stock 026 and another to build to compare to witj one of those kits.
will be placing an order too.either tonight or tomorrow.

OK. Let me know when that order goes in.

 

[Gentleman]

I could do a 260.......

OK. Send me the address.

 

[Jughead]

OK. Let me know when that order goes in.

will do.

 

[Stihlsmoking]

I've got a 036 I need to finish ? I'm just your average novice so I could try a 360 see how it does on a old red lever saw ? Do both top ends on same saw.

 

[kkemp]

I could do the ms 290 if No one else does. but I'm also just your average guy too . Don't want to step in front of any one else that is an expert though.

 

[Chainsaw Jim]

I can do the ms360. I have a near new one for a clean plug and play with a full stock set up to do a two video comparison between your jug and a stock jug.

 

[Stump Shot]

Have a complete and running MS360 here I that I could swap out and test for you fast if you would like.

 

[Wagnerwerks]

I could also do an 029 or 39...

 

[dustinwilt68]

I have a ms 360 pro, I can swap it right on and report back.

 

[drf256]

I can do 260 and 360. I'm more interested in how/if they can be modified.

 

[peter92]

I have a 2 pcs each of nikasil cylinder samples for MS260, MS360, MS290. Who wants to test? You have to make a thread and report back.

Wondering what you are expecting in the report
Peter

 

[Jughead]

OK. Let me know when that order goes in.

pm sent sir

 

[Gentleman]

Wondering what you are expecting in the report

I'd like to see port timing, compression, finish, plating, overall quality...

 

[Gentleman]

I could also do an 029 or 39...

Sending today

 

[Gentleman]

The 260's and 360' are gone.
I still have the 290's