What's on your bench?

[czar800]

Did a few minutes of research and found out my problem is most likely The carburetor solenoid. # 0000 120 5110

 

[dustinwilt68]

Can't wait to get down to NC to see my 281 and 288, once Rattled they sure do run great! Thanks again Mike!

 

[blsnelling]

There steam phosphating steel parts takes all the oils off and have to dry right away

Thanks brad. You open solo parts yet

Feeling better i hope


Sent from my iPad using Tapatalk

I have not. I've had a lot of pain this week and haven't done much of anything besides sleep or lay in my recliner.

 

[rattler]

Can't wait to get down to NC to see my 281 and 288, once Rattled they sure do run great! Thanks again Mike!

Welcome buddy.

 

[MustangMike]

I have not. I've had a lot of pain this week and haven't done much of anything besides sleep or lay in my recliner.

Brad, I know I have told you previously that my brother has also struggled with intestinal problems for many years now. They wanted to put him on full disability, but he would not hear of it. Stay strong, it is a tough fight, and all the best to you.

 

[Canadian farm boy]

Closer to being done. Just need to give it a good look over and then stone it.

 

[huskihl]

Closer to being done. Just need to give it a good look over and then stone it. View attachment 103803View attachment 103804

Still trying to catch my 372 I see.....

 

[dustinwilt68]

What saw you run that chain on?

 

[backhoelover]

At the shop boys are steaming some parts outside in 15 degree weather

Had some parts powdered too

Pretty

Steam clean probably gets a saw clean a puck

 

[backhoelover]

Yes it was covered under warranty, it is an "Exmark" engine which appears to be a clone of the GXV Honda.

Joe will a 395 cylinder fit a 394?

 

[dustinwilt68]

Yes but you have to change the intake tract, carb and filter elbow as well.

 

[beaglebriar]

Yes but you have to change the intake tract, carb and filter elbow as well.

Add an impulse nipple to the carb.

 

[dustinwilt68]

Still won't fix the carb being offset.

 

[Onan18]

Yes but you have to change the intake tract, carb and filter elbow as well.

Add an impulse nipple to the carb.

Still won't fix the carb being offset.

@backhoelover what they said.

 

[Mattyo]

ideally you want to change the carb base too. you can mod the 394 carb base to fit a 395, but its not as easy to go the other way iirc. AND the 394 carb bases are discontinued...

 

[Drptrch]

A little post training rehab [emoji106]


Erik

 

[Canadian farm boy]

What saw you run that chain on?

The chain is actually for a friend but
I'll test it on either my ms461 or my 044 hybrid before it leaves.

 

[Moparmyway]

Add an impulse nipple to the carb.

395 carb has the nipple already

First two are 394, last two are 395

 

[Onan18]

A few T540 XPs.

 

[dustinwilt68]

Sorry Joe, those suck to work on.