What's on your bench?

[Mark71gtx]

I just picked up a NOS CS-500 that appears to have been used for parts at a dealer when new. The whole top section and tank are gone. No carb or intake parts. The rest of the saw is there and there is not a scratch on it. I'll eventually sell it I am sure.

 

[exSW]

I just picked up a NOS CS-500 that appears to have been used for parts at a dealer when new. The whole top section and tank are gone. No carb or intake parts. The rest of the saw is there and there is not a scratch on it. I'll eventually sell it I am sure.

I have a 951 Olympik like that. Missing the coil,clutch and air filter.

 

[Mark71gtx]

The difference is yours is probably worth finding the missing pieces to complete it...

 

[Keith Gandy]

Redone 52mm 064

 

[PA Dan]

Redone 52mm 064View attachment 21797View attachment 21798

Very nice Keith![emoji6]

 

[Mark71gtx]

Fantastic job!

 

[Canadian farm boy]

Beautiful job as always Keith. Now the real question is does it run as good as it looks?

 

[paragonbuilder]

Redone 52mm 064View attachment 21797View attachment 21798

Stock or ported?

 

[Keith Gandy]

Stock or ported?

Ported . It hadnt seen wood since I redone but feels strong. Its sold to a treeservice in Florida

 

[Keith Gandy]

Deleted gasket, 101/118/78, MM, advanced timing,and walbro wj69. New gas tank but the farmertech didnt fit the older flattop carb housing. Had to trim housing and relocate an on/off toggle to the redlight location

 

[paragonbuilder]

Deleted gasket, 101/118/78, MM, advanced timing,and walbro wj69. New gas tank but tue farmertech didnt fit the older flattop carb housing. Had to trim housing and relocate an on/off toggle to the redlight location

I'm sure they will !be thrilled with it

 

[czar800]

Nice work!

 

[mdavlee]

385 and 7900 for porting are across my benches.

 

[Sty57]

This is my 372XT from boxes, I thing I have parts off three different saws one it so far. LOL
Before with bad crank, bearings , piston and Jug and missing a bunch of stuff.

After, It's now an XPG and getting closer to being done.

 

[Tor R]

This is my 372XT from boxes, I thing I have parts off three different saws one it so far. LOL
Before with bad crank, bearings , piston and Jug and missing a bunch of stuff.
View attachment 21803
After, It's now an XPG and getting closer to being done.
View attachment 21804

wow, that is impressive, absolutly stunning work!
Mine always look like the one you got, but none look like the result you was able to build

 

[Sty57]

wow, that is impressive, absolutly stunning work!
Mine always look like the one you got, but none look like the result you was able to build

Thanks Tor, I seem to get a little carried away when I start a build. LOL

 

[VinceGU05]

only if it runs!

She runs perfectly now with fresh fuel. And oils great too. [emoji1360]

 

[rattler]

Sent from my XT1060 using Tapatalk

 

[mdavlee]

Sent from my XT1060 using Tapatalk

Looks about like my vise. I just cut a 7900 jug about .015".

 

[rattler]

That has been a handy little vice. I got a bigger on I need to mount it the shop some were. I found a single phase Bridgeport I would really like to have.

Sent from my XT1060 using Tapatalk