Spacing saw tune-up.

[Boomer2230]

I have a 2016 FS 560C spacing saw that I need to service, I believe it's M-tronic. What tools are needed to work on this saw? I mean the computer tools, not the hand tools.

 

[Int1968]

Dealer only as far as I know, maybe ask mastermind.

 

[JugHead27]

If it seems to be running really rich and bogging make sure to take out the muffler spark arrestor and blowtorch the soot/gunk out of the screen. You can calibrate m tronics by warming the saw up, then shutting down and starting and it in start position and let it run for 30 seconds, then blip the throttle.

 

[cuinrearview]

@PA Dan didn't you go down this hole?

 

[Boomer2230]

Dealer only as far as I know, maybe ask mastermind.

@Mastermind , do you have any info on the programmer?

 

[Mastermind]

Dealer can sell the MDG reader.

What symptoms does your machine have?

 

[Boomer2230]

Sa

Dealer can sell the MDG reader.

What symptoms does your machine have?

Saw starts but bog, I can get it to Rev up after a bit, it's just not running properly, and it's spark arest screen is clean.

 

[Mastermind]

Sa

Saw starts but bog, I can get it to Rev up after a bit, it's just not running properly, and it's spark arest screen is clean.

Does it seem to be flooding? Hard to start? The most common problem with any M-Tronic is a leaking solenoid. Which causes flooding.