Solo 665 thread

[dustinwilt68]

Beautiful work, you guys are a true inspiration. Man that lathe is better then looking at porn! Sweet.

 

[Tundra]

Looks like top notch work there deets. I'm looking forward to a video also.

 

[Deets066]

I didn't get time to work on it today, thought I was going to but, other priorities

 

[Deets066]

Ok I took a little time to put the wheel on the solo.
Ported timing
Ex 101
Trans 131/134
Intake 83.5

 

[Deets066]

Figured as long as I was out here I'd just finish it up.

 

[Deets066]

 

[huskihl]

View attachment 52392

Solo....Dolmar meets Husqvarna and Partner toaster. She's a beauty

 

[dustinwilt68]

Very nice Deets, let us know how it runs.

 

[Deets066]

Solo....Dolmar meets Husqvarna and Partner toaster. She's a beauty

They are a well put together saw too

 

[Deets066]

Very nice Deets, let us know how it runs.

 

[huskihl]

That bar though.....

 

[expert of nothing]

View attachment 52392

Nice work, looks like a gas powered computer.If it was mine it would be on my kitchen table.NICE...

 

[dustinwilt68]

Looking good!

 

[Deets066]

Looking good!

It felt good after I got the carb close. Kinda weird, I had to lean out the H a full turn from when it was stock. As Mike said, it's pulling a lot more air through the Venturi which makes it flow more fuel

 

[expert of nothing]

It felt good after I got the carb close. Kinda weird, I had to lean out the H a full turn from when it was stock. As Mike said, it's pulling a lot more air through the Venturi which makes it flow more fuel

A lot of folks think more flow = more fuel the opposite, you gotta lean that dude out. Turn H screw in LOL.More air flow more fuel , ya gotta lean her out a bit. Trust me.Spent a lot of years in moto-cross. I got this sh.. thanks fer listnin.Mikes got it right, trust him!When you port it you got to turn H in to make engine happy.

 

[Deets066]

I'll get her tuned up right tomorrow, I need to get it in some wood

 

[Dub11]

I like me some piss rev!

 

[stihl livin]

Hurry up deetsy

 

[Mastermind]

I'm predicting that you will want to take the transfers up just a wee bit.

 

[Deets066]

I'm predicting that you will want to take the transfers up just a wee bit.

Yeah I'm sure I will, just want to see the difference that it makes. Probly 126/128 is where I'd go next