Saw video thread

[Mastermind]

Yea old 3120XPee

 

[Crocky28]

View this content on Instagram

View this content on Instagram

It’s been a while

 

[Mastermind]

MS461 with Wiseco slug.

 

[BonScott46]

Flat top 066 cutting some bigger rounds of birch with a so so chain. Came to me blown up so I salvaged the cylinder and put a meteor in it, dual port muffler.

 

[Canadian farm boy]

Went straight out of the box to the bench for some “tweaking”. Less than 1/2 a tank of fuel run through it when I made the vid.

 

[Canadian farm boy]

This is actually the second time I ran the saw. The first time I tried testing it the saw would start right up and piss rev great. Sink it in wood and it’d fall on its face and stall. I found out the hard way you have to watch the fuel line where it comes into the carb box. The hose is super soft and really easy to kink over if it’s not just right.

 

[huskihl]

This is actually the second time I ran the saw. The first time I tried testing it the saw would start right up and piss rev great. Sink it in wood and it’d fall on its face and stall. I found out the hard way you have to watch the fuel line where it comes into the carb box. The hose is super soft and really easy to kink over if it’s not just right.

Too bad they’re not quite as fun taking them apart as they are running them. They are a complete pain in the ass.

She run good Mikey

 

[Canadian farm boy]

Too bad they’re not quite as fun taking them apart as they are running them. They are a complete pain in the ass.

She run good Mikey

Twas an experience. Lol

 

[heimannm]

 

[Mastermind]

Nicely done my friend.