Saw video thread

[Hot Husky 365]

Thanks for the welcome!

 

[mdavlee]

Thanks for the welcome!

Don't cut all your square wood up in one day[emoji1]

 

[Frank bierce]

Thanks for the welcome!

Welcome to the nut house!! Nice saw you have there!!

 

[trooney]

Hey Andrew, welcome and have a good time! Nice saw, and I like your 346 too!! So much so I got me one!

 

[mdavlee]

Slowlo

 

[mdavlee]

Clint's 2171 same chain as Solo

 

[paragonbuilder]

Slowlo

Clint's 2171 same chain as Solo

By eye the solo looks faster.

 

[mdavlee]

By eye the solo looks faster.

Fastest cuts with each was .12 different. Not bad for 10cc spread.

 

[paragonbuilder]

Fastest cuts with each was .12 different. Not bad for 10cc spread.

Not bad for the smaller one...[emoji6]

 

[mdavlee]

 

[mdavlee]

 

[RI Chevy]

Runs nice Mike.

 

[Crzybowhntr]

@jmssaws do you use square filed chain or Chisel in the videos you post?

 

[Crzybowhntr]

That's a strong runner there!

 

[mdavlee]

Runs nice Mike.

I hated to box it up and send it west. I ran 2 whole tanks through it. 1.5 were cookies I bet.

 

[RI Chevy]

Lol. Real smooth powerband. Held RPM'S well.

 

[mdavlee]

Lol. Real smooth powerband. Held RPM'S well.

It does. Very strong for 70cc.

 

[jmssaws]

Here's the Christmas saw one last time
Tuned fat and then a sharp work tune
3/8 7pin and in both videos it's 12 degrees

 

[jmssaws]

@jmssaws do you use square filed chain or Chisel in the videos you post?

I always run square filed

 

[PA Dan]

I hated to box it up and send it west. I ran 2 whole tanks through it. 1.5 were cookies I bet.

Is that Clints saw?