Saw video thread

[RI Chevy]

Nice. Can anyone get access to that diagnostic program?

 

[malk315]

Here's a 261 I hooked up to the MDG1. Didn't run any full test on it.

And checking rpm.

That is way cool. Reminds me of my dyno display a bit. That is stihls software for monitoring mtronic?

Lol... Autocorrect keeps wanting to change mtronic to moronic

Sent from my XT1585 using Tapatalk

 

[RI Chevy]

Lol. Nice Eric.
With the Tachs.

 

[X 66 stang347 X]

Far as I know anyone can. Will have to check no ones ever asked. It is stihls software. On the 500i everything can be monitored. Kinda like a car

 

[RI Chevy]

That is cool software. Is there a port for a wire on the saw?

 

[X 66 stang347 X]

Yes every saw. This one was on side of carb. Might can see in this pic.

 

[RI Chevy]

Cool
Thanks for the pics

 

[jmssaws]

Finished up a nice 066 arctic today
Ran it with a 661 and a 9pin

 

[X 66 stang347 X]

Nice. Living down here in the south I've never messed with a arctic. I Like the way that 661 sounds. With the 9 pin it still wants some load.

 

[jmssaws]

Nice. Living down here in the south I've never messed with a arctic. I Like the way that 661 sounds. With the 9 pin it still wants some load.

The more you load it the stronger it seems to get.
If I was cutting timber still there's nothing else I would use.

 

[RI Chevy]

Jason. Are the 661's as easy to work on as the 660's?

 

[Stihlsmoking]

What about nylon mesh air filters?

He said fleece is the worst, nylon mesh is better. He said my saw would be fine with one, but I had him do the metal mesh for best air flow with out going velocity stack.

 

[jmssaws]

Jason. Are the 661's as easy to work on as the 660's?

Not quite but still very simple.
I can put one together with my eyes closed now. Lol

 

[RI Chevy]

Lol. Cool.

 

[X 66 stang347 X]

I bet because it's always at optimal timing. It knows load by rpm and throttle angle. Then adjusts timing accordingly. Could be

 

[CR500]

Not quite but still very simple.
I can put one together with my eyes closed now. Lol

You are welcome lol

 

[jmssaws]

You are welcome lol

Your 661 isn't as simple.
Damn arctic has wires everywhere

 

[CR500]

I know I changed the cylinder before you ported it...


Could not believe all those wires....

 

[jeepsnchainsaws]

Just something different for 30 seconds
1050 on year old sludge in fresh Red Oak.

 

[jmssaws]

I know I changed the cylinder before you ported it...


Could not believe all those wires....

The handle bar is the bad part on yours