Post up your ported cylinder Artwork

[Shane¹]

Husqvarna 357xp. Hopefully it runs

 

[Sloughfoot]

Husqvarna 357xp. Hopefully it runs

View attachment 471971

View attachment 471970

View attachment 471972

What all did you do to it?

 

[lehman live edge slab]

What all did you do to it?

Ground the holes bigger

 

[Shane¹]

What all did you do to it?

Cut band,cut base, raised transfers, raised and widened exhaust, lowered intake

 

[Sloughfoot]

Cut band,cut base, raised transfers, raised and widened exhaust, lowered intake

Got my first attempt at raising transfers coming up soon, without an angle handpiece to make it more tedious than it already is.

 

[Shane¹]

Got my first attempt at raising transfers coming up soon, without an angle handpiece to make it more tedious than it already is.

If your budget will ever allow. I can definitely recommend getting one of the @srcarr52 90 degree grinders it is awesome. I have only done about 4 cylinders with mine but I would not be without it for porting now. Way better than the cheap junky one I had that was too big to even get into the ports before.

 

[Sloughfoot]

If your budget will ever allow. I can definitely recommend getting one of the @srcarr52 90 degree grinders it is awesome. I have only done about 4 cylinders with mine but I would not be without it for porting now. Way better than the cheap junky one I had that was too big to even get into the ports before.

Been tempted to do that. Probably will if I fubr this little 026 44mm with little cutoff wheels on a straight foredom.

 

[lehman live edge slab]

Been tempted to do that. Probably will if I fubr this little 026 44mm with little cutoff wheels on a straight foredom.

Sounds kinda silly to possibly wreck a 100 dollar cylinder because you don’t want to buy the 250$ tool until you mess it up. So out a cylinder plus the tool money or just buy the tool?

 

[Sloughfoot]

Sounds kinda silly to possibly wreck a 100 dollar cylinder because you don’t want to buy the 250$ tool until you mess it up. So out a cylinder plus the tool money or just buy the tool?435

Take it easy. It's not a $100 cylinder it's a $35 cylinder and it's not your $35.

 

[Bjorn]

If your budget will ever allow. I can definitely recommend getting one of the @srcarr52 90 degree grinders it is awesome. I have only done about 4 cylinders with mine but I would not be without it for porting now. Way better than the cheap junky one I had that was too big to even get into the ports before.

What is the differens if you do it right.