Not So Pro 3

[dall]

Whoa! Is it noon already?

Yes

What do you mean that it’s running hotter? Are you checking its cylinder temperature with an infrared or something? Lots of variables here..

The forbidden word

 

[John Wargo]

Working on the beams and floor panels for our mass timber mock up project. Dumped 3.5 inches of water out of the rain guage last night.

 

[Mastermind]

Morning gentlemen, can anyone answer why my local dealer can't run diagnostic on mtronic, saw is plugged in and reads error, yet he has no problems reading other saws fine, it's a early 2018 model 462 with alot of run time, the saw is running slightly hotter than usual, any he's going to tear it apart

Could be a lot of things that keeps it from reading. Trigger unit on the carb, wiring harness, module, etc....

 

[Loony661]

Hotter to the touch than normal

Is it still running normally?

Check/clean the cylinder fins.

 

[Tor R]

Good morning marsupials,

I have trained:

 

[Woodrow]

Good morning fellas.

 

[nbbt]

Good morning folks. Coffee is seeming better than normal with it starting out at 46f this morning, near 66f a bit later.

 

[ray benson]

Good morning. 63°F/ 17°C going up to 68°F/ 20°C. Dropping to about 46°F/ 8°C by tomorrow morning.

 

[Nighthunter]

Saw running fine other than getting hot and wont show up on mtronic diagnostic, saw is clean, it's cleaned daily for a work saw

Is it still running normally?

Check/clean the cylinder fins.

 

[p61 western]

Good morning fellas