JONSERED Jonsereds

[davidwyby]

I think I’d like to try a 70e. Nah, bigger..what would be the last metal 80-90cc?

 

[afleetcommand]

How about the little ones. Here working a 455 & 451e

 

[davidwyby]

Novice lumberjack is looking for the owner of a stolen jonsered similar to a 2165.

 

[heimannm]

751 cleaned up and ready to go to the display.







Starts, runs, idles, and oils. I am unwilling to get it all dirty so I will just enjoy the sound for now.

Mark

 

[heimannm]

I also went through this 621 this week. It was pretty rough when it came in.





I like to start by giving everything a good scrub and inspection.



I discovered there was a leak at the joint between the cylinder and crankcase so I removed the gasket and put it together with Threebond. The carburetor also needed a little cleaning, the air filters on these were nothing more than a brass screen.



Mark

 

[heimannm]

The saw now starts, runs, idles, and oils. I will be looking for a clutch or clutch spring as the idle speed needs to be so low (to keep the chain from moving) that the engine will stall at times.











I don't really need three of these (two are in the display already) so I'll either keep it for a GTG saw or sell it if anyone would like one.

Mark

 

[Johnmn]

The saw now starts, runs, idles, and oils. I will be looking for a clutch or clutch spring as the idle speed needs to be so low (to keep the chain from moving) that the engine will stall at times.

View attachment 418260

View attachment 418261

View attachment 418262

View attachment 418263

View attachment 418264

I don't really need three of these (two are in the display already) so I'll either keep it for a GTG saw or sell it if anyone would like one.

Mark

I may have a 621 clutch for you I’ll take a look this weekend.

 

[heimannm]

The 751 was so close to the test log, but I resisted as I didn't want to have to go through the cleaning again before putting it up.

Mark

 

[Gvsu141]

Traded my good friend one of those old yellow saws for this really nice 621 this week.

Does anybody have the steel mesh for the recoil? Or a busted recoil that I could scavenge it from? This one's missing a chunk. Recoil has nice paint and works fine otherwise.