Early 064 build

[mtnwkr]

Good to hear, Lets turn it up a bit! Thanks.

 

[BuckthornBonnie]

I have a couple and they're both stock besides simple muffler mods. They tune differently despite both having Bing carbs--- the one I use for noodling I like around 12,600 with a good 4-stroke. The other is 13ish. Both sound ok and could go leaner.

 

[mtnwkr]

Thanks for your input. I wonder why they are rated at 12,000rpm max in the service manual?

 

[BuckthornBonnie]

Thanks for your input. I wonder why they are rated at 12,000rpm max in the service manual?

Not sure on that one except that it's below the limiter on the cdic models. Conservative tune, probably saved quite a few saws from being "on the edge."

 

[BuckthornBonnie]

Also I had the tach on my 064 today after replacing the af. I put an AM white pleated one on it in place of the hd. I'm comfy at 12,200 til I get a chance to re-tune it in wood. It'll probably be closer to 13,000 after that-- slight mm, 28" bar.

 

[Donwon2525]

I owe you one.
I have a lot of 064 stuff so let me know if you need anything

Found this in a old forum do u happen to have a 064 recoil and flywheel you would wanna sell by chance?

 

[Dub11]

Found this in a old forum do u happen to have a 064 recoil and flywheel you would wanna sell by chance?

That thieving scamming peice of *s-word has been banned from here for a while now.

I'm sure someone else here could help you out with them parts.