2011 husqvarna 562 high end bog/stall???

[Toad22t]

No sir. I hate to say it out loud Keith.......I'm afraid it might stop helping. lol

I've been increasing pop-off pressure. I know.......ass backward from everything we think we should do. It has fixed a few now though.

So instead of shorting the spring you stretch it?

 

[Mastermind]

So instead of shorting the spring you stretch it?

Yeppers.

 

[Chainsaw Jim]

Its a Husqvarna, so probably should go ahead and check all the bolts.

This just pisses me off to the point I will never have another 562. They put a *s-wordty carb on it at the factory, and then charge you $100+ to get your saw running the way it always should've run. Every f*cking one of these should be replaced, at no cost to anyone but Husqvarna. *a-holes.

Best out of the box 60cc saw on the planet.

 

[Keith Gandy]

Best out of the box 60cc saw on the planet.

I agree

 

[cgraham1]

Best out of the box 60cc saw on the planet.

Don't care.

 

[Chainsaw Jim]

Don't care.

I couldn't resist.

 

[sunfish]

Don't care.

Best answer.

It only maters if it maters.

Don't care either.

 

[Mastermind]

Best out of the box 60cc saw on the planet.

Yeah, they are great saws. I just wish they were a little more durable.

 

[sunfish]

Probably run an Echo,

If I had an Echo.

But it doesn't mater.

 

[Mastermind]

The most hours I've ever seen on a 562 was just over 100. It needed a new crankshaft, and a new top end. But it was great.

 

[Mastermind]

I couldn't resist either.

 

[Red97]

Don't know if this site can handle the 60cc videos I just shot all in one place...

 

[sunfish]

Fixin to have too many ported 357s' here.

 

[Chainsaw Jim]

Yeah, they are great saws. I just wish they were a little more durable.

The worst hose job I've ever been dealt on a saw. I drove over 200 friggin miles to buy one that ended up having a blown bottom end. Even after having a good chunk of cash pulled off the top for it not firing on the spot. Those wretched plastic bearing cages.

 

[angelo c]

Best out of the box 60cc saw on the planet.

Did someone say MS 362 ????

 

[Mastermind]

I sorta like the MS362C. The newest version is pretty damn sporty. I have seen a few crank failures in them too though.

 

[cgraham1]

I sorta like the MS362C. The newest version is pretty damn sporty. I have seen a few crank failures in them too though.

262xp FTW.

 

[Keith Gandy]

262xp FTW.

A guy is bringing one to give to me in awhile. Said it ran but the pullcord broke

 

[Idahonative]

I don't know how many hours, but around 100 would be a good guess. The 562 isn't the saw I run most of the time.

My point exactly. You never miss an opportunity to tell all of us how "fantastic" the 562 is but it isn't your first choice when you need a saw in that class. Apparently there are other saws that are "fantastic...er" LOL.

 

[Duce]

^^^^ We already know you are a 562xp Hater. But, some people do like theirs.