Saw video thread

[Ronie]

Another 350

 

[RI Chevy]

Nice job. 350 sounded a bit lean on muh phone. Sometimes saws are a bit stronger in the cut when they are a tad on the rich side..
Nice job on the saws though...[emoji106]

 

[Ronie]

2165 with a 372 cylinder and a pop up 268 non windowed piston. It pulls a 24 nicely.

 

[Ronie]

365

 

[Ronie]

2159 Hyway 357 top end.

 

[Ronie]

Hyway 288 I just finshed a couple of weeks ago.

 

[Ronie]

My last one, 371.

 

[Ronie]

Nice job. 350 sounded a bit lean on muh phone. Sometimes saws are a bit stronger in the cut when they are a tad on the rich side..
Nice job on the saws though...[emoji106]

I richend it up a little after that video

 

[RI Chevy]

Nice! [emoji106]

 

[Ronie]

I know them saws aren't awesome to most here but but they are to me because I did them myself with a little help from some forum members.

 

[RI Chevy]

I richend it up a little after that video

Cool. What chain are you running on these saws? 325 or 3/8?

 

[RI Chevy]

I know them saws aren't awesome to most here but but they are to me because I did them myself with a little help from some forum members.

Ya did good...[emoji481]

 

[Ronie]

Nice!

[/QU

Cool. What chain are you running on these saws? 325 or 3/8?

They all have 3/8 full chisel.

 

[Ronie]

Forgot one, 2172 ported, pop up and the dividers removed from the intake.

 

[PA Dan]

I had Dallas weld a 1/2" ID pipe on the side of my 201t muffler.

 

[Canadian farm boy]

 

[redlight066]

 

[RI Chevy]

Nice Rich!
2511 spot on with the tune.
460 a bit lean...
Nice job though.

 

[TreeLife]

My last one, 371.

This sounded stout. Well done

 

[redlight066]

Nice Rich!
2511 spot on with the tune.
460 a bit lean...
Nice job though.

Thanks. Started with .031 squish, 72 122 102. Took .040 off the base and set the squish to .020. Ended up at 79 123 99. Both with factory gasket. I Could still lean on it pretty hard. Yes a tick lean after the cut and corrected.