Search results

Looking for opinions / comments here - i bought a new 572 10 months ago and 14 months left on warranty. Been really hard to find dealer close that has software for electronic carb but found one. Saw has been run very little since i purchased from member last April. Saw ran great until last...

I have to post this for the fellas like me that have wondered or thought about buying water stove instead of burning a wood insert in fireplace in the basement to heat their home - that’s what I’ve done for years until. Now as far as savings it’s hard to say because i have a huge thermopride...

I bought a used 372 looks rough but starts great and runs but doesn’t have the power of other 372’s i have. It’s missing brake handle and plastic is rough. I want to replace p/c but would like to ask what you would replace brand wise. Assuming the bearings and seals are good is there anything...

Recent 394 to 395 conversion. Starts runs cuts great but after a good hard cut when i pull it out of log and let off throttle and as rpms drop it cuts off. It will start right back up but don’t really understand why it cuts off. If i keep throttle to it it keeps running and it idles ok. Does...

Cut off saw needs a new carb walbro hd30. Can’t find it anywhere but can get kit for it but wouldn’t mind just a new carb. Does anyone know if a carb for a 371 chainsaw would work it’s a hd 12 or a hd 6 for 371 chainsaw and they are available reasonable just not sure if it will work ?

I’m in need of the high top style top cover and filter setup for a 395/394. I have the low top cover and the cover that goes over plug and air filter and new filter but need the bigger filter and cover like they use for milling. This is for a 394 that was converted to 395 with new intake and...

Don't really want to sell but would like to trade - I have a cylinder that i was going to use for a rebuild of 394 but decided to go 395 conversion route. The cylinder looks great and i will be glad to send pics or let you look at cylinder before deciding. I used muriatic acid to clean...

394 to 395 conversion but with a new 395 carb and intake installed. Looks exactly like a 395 now with p/c and intake and when trying to adjust carb low screw didn't make much difference in adjusting and saw wouldn't hum would run idle just wouldn't clear up. Vac test good new seals so while...

husky 394 - anybody tried the hutzl ? Just curious becaus they are so cheap and i believe you get what u pay for but had to ask. If not oiling like it should and has a new pick up and filter and black wheel looks good can you just replace piston pump or whole pump need replacing usually ? I...

i have a 394 with conversion to 395 and everything has gone great up until i try to start for first time. No fire at plug. It has a new Oem coil new Oem plug wire new spark plug and tried two different new plugs New switch new kill wire . Even pulled kill wire from coil. Key is in...

I have a husqvarna 257 made in 1997 that just doesn’t oil like it should for long time. Doesn’t even use half tank of oil per fuel tank. I have open up Oiler screw and if it’s oiling then not much. You can tell while running saw it’s not oiling enough. It has the right bar and holes are...

Fellas i have a 394 that got run without oil in gas. I have no money in it and saw was fairly new when it got ruined and has been sitting under workbench for years. Cylinder has cleaned up very well and my question is has anyone bought the kit to convert and had good results. I’ve searched...