- Local time
- 12:37 AM
- User ID
- 1204
- Joined
- Apr 28, 2016
- Messages
- 11,589
- Reaction score
- 44,139
- Location
- Croatia
I have been meaning to try this, never seemed to get to it.
This is how I tighten my saws clutch cover/bar nuts.
The scrench lever is 14.5cm/5.7" long (Dolmar OEM) and I am a lefty meaning I tighten with my strong hand.
I tried loosening the nuts with the only torque wrench I own, but its lowest setting was higher than the nuts tightness.
As such all I could conclude the nuts are noticeably less tight than 42Nm.
Test fail?
No, not really - just not fully conclusive.
Someone can pick up from here and build on it.
Cheers!
This is how I tighten my saws clutch cover/bar nuts.
The scrench lever is 14.5cm/5.7" long (Dolmar OEM) and I am a lefty meaning I tighten with my strong hand.
I tried loosening the nuts with the only torque wrench I own, but its lowest setting was higher than the nuts tightness.
As such all I could conclude the nuts are noticeably less tight than 42Nm.
Test fail?
No, not really - just not fully conclusive.
Someone can pick up from here and build on it.
Cheers!