sh!t happens

[tree monkey]

 

[bwalker]

Ouch!

 

[Ketchup]

How???

 

[huskihl]

What’s the muffler look like? I’ve had one 372 and one 390 do it. I figured either the muffler took a hit or the front bracket holes weren’t slotted quite enough after lowering the cylinder

 

[EFSM]

It looks like the cylinder was ported—is there a chance the base wasn’t flat, or the crankcase for that matter?

 

[16TAF]

Don’t see that very often

 

[EFSM]

What’s the muffler look like? I’ve had one 372 and one 390 do it. I figured either the muffler took a hit or the front bracket holes weren’t slotted quite enough after lowering the cylinder

Maybe…but it’s broken sideways.

 

[drumbum]

Classic Opti-2 @ 80-1 damage,....seen it a brazillion times.....


lol

 

[Stump Shot]

Only had one so far pop it's top, in that case it was from hydro-locking.

 

[huskihl]

Maybe…but it’s broken sideways.

Yeah I saw that. Mine were broken on the front. Could’ve taken the same hit from the side though

 

[EFSM]

Only had one so far pop it's top, in that case it was from hydro-locking.

Water ingestion while running?

 

[MG2186]

It looks like the cylinder was ported—is there a chance the base wasn’t flat, or the crankcase for that matter?

Pretty sure Scot said it’s one he ported, was fairly low hour’d saw

 

[Junk Meister]

Pretty sure Scot said it’s one he ported, was fairly low hour’d saw

At 20 min in he said the owner has had it for quite a while "ported" never did say by whom..

 

[huskihl]

At 20 min in he said the owner has had it for quite a while "ported" never did say by whom..

I’m not sure what part of the video it was, but I think Scott said it was one of his saws, meaning he ported it

 

[EFSM]

Pretty sure Scot said it’s one he ported, was fairly low hour’d saw

I didn’t watch the whole vid. Did it have a base gasket or was it bolted straight to the crankcase with sealant? It seems like a gasket would be a bit more forgiving.

 

[Sloughfoot]

I’m not sure what part of the video it was, but I think Scott said it was one of his saws, meaning he ported it

"not my saw" is what I heard around 20:20 and "I ported it" near the end.

 

[Wood Doctor]

Get this: the year was 1976 and I had just bought a new chainsaw with a 16" B/C. One of the guys at work heard about it and asked to borrow it. I said OK. He gave it back a week later with a dull chain and a burned out engine (straight gassed). Dealer said it would cost $180 to rebuild it, exactly what I paid for it. I shook my head and said, "I will never loan out another one of my new good saws."

 

[drumbum]

Get this: the year was 1976 and I had just bought a new chainsaw with a 16" B/C. One of the guys at work heard about it and asked to borrow it. I said OK. He gave it back a week later with a dull chain and a burned out engine (straight gassed). Dealer said it would cost $180 to rebuild it, exactly what I paid for it. I shook my head and said, "I will never loan out another one of my saws."

FIFY

 

[Stump Shot]

Water ingestion while running?

Fuel mix leaked into the crankcase from a leaking needle and seat in the carburetor, it fired up and next revolution went pop.

 

[tree monkey]