Saw video thread

[Wolverine]

Ok, so this obviously isn't my vid so ban me if you must (but make it a short one please). I found this vid of an old Dolly and had to share cause it's so cool. I have it set to go right to 9:03 but the rest is pretty cool too, especially if you like old machinery.

 

[RI Chevy]

Something wrong with your link.

 

[Wolverine]

Something wrong with your link.

Looks good on my end...

 

[RI Chevy]

OK. It works from a web browser, and does not work from Tapatalk.
Cool Old Dolmar 2 handed saw.

 

[Frank bierce]

Ok, so this obviously isn't my vid so ban me if you must (but make it a short one please). I found this vid of an old Dolly and had to share cause it's so cool. I have it set to go right to 9:03 but the rest is pretty cool too, especially if you like old machinery.

Awesome video!! That yhing was movin some chips...right into the cutters boot!! Lol

 

[Duane(Pa)]

My shoulders ache just watching that!

 

[mdavlee]

Build off 066 from years ago.

Treemonkey 390

 

[Deets066]

Here's the first port job on the hybrid, its had a few cylinder sets on it since then.

 

[A.E.E.llc]

Balsa wood have knots?

 

[Deets066]

Balsa wood have knots?

Styrofoam????

 

[A.E.E.llc]

Styrofoam????

Could be the rpminthestoam or crust wood. Not for sure.

 

[drf256]

Nice Job there my elvin compadré.

 

[paragonbuilder]

Balsa wood have knots?

Wowser! That's fast!!

 

[mdavlee]

385 noodling.

 

[mdavlee]

404 on the 385 and 3/8" on the 046.

 

[mdavlee]

Stock 3120 with 404 7 pin

 

[MustangMike]

Forgive my bias, but that 046 looked like it had some snot!

 

[mdavlee]

Forgive my bias, but that 046 looked like it had some snot!

404 and 3/8". Not bad to not have the base or chamber cut. 404 slows them saws down. 3120 don't seem to mind it.

 

[MustangMike]

I never said the playing field was level, I did see all that. But since I use 3/8, ...

 

[mdavlee]

I never said the playing field was level, I did see all that. But since I use 3/8, ...

That saw is ported like they say is wrong. Finger ports with just a gasket delete. It pulls just fine for a work saw.