Saw video thread

[Slumberjack]

my 262xp wif out da box stihl rs. Man that’s good stuff. Rich tune just so I could beat on it a bit and see what it had for balls.

 

[president]

Cool. Thanks Kevin.
Thanks Tony.
Thanks for sharing that information.

Pioneer600,did a port job as a gift for worksaw use
He did an amazing job and the torque he got out of it
was amazing! He used a non decomp 12 mill jug ,and
it Idles great and spools up beautifly
I gave him a NOS jug and piston/ decomp
one and he opted to use the earlier jug.

 

[huskyboy]

 

[huskyboy]

 

[Maintenance Chief]

Were you watching the tach in the first cut?

 

[huskyboy]

Were you watching the tach in the first cut?

Yes, the 395 liked to run around 10,000rpm in cut and 390 was running around 9 - 9600rpm. I don’t hold them to a certain rpm. I run them where they cut the best by feel with the bar length they are running and the wood type. Just glance at the tach reading for curiosity and check tune if needed.

 

[Ronie]

I used this saw all last week without a problem, thought I make a video of it running and it decided that today is the day it would crap out on me. Fortunately, it was only a bad purge bulb and it's back up and running like it should. It's hard to see in the pic, but the little valve in the bulb came apart.

 

[Ronie]

Running good now.

 

[huskyboy]

Went back into the 372.

 

[Lightning Performance]

Went back into the 372.

Your going to wear out your chain on that log.
Damn good runners there

 

[huskyboy]

Your going to wear out your chain on that log.
Damn good runners there

Damn hard norf east ash lol

 

[Slumberjack]

Just a different chain without a *s-word ton off the rakers and hand filed it cut faster and didn’t beat my hands to hell. Lol

 

[ZukiRyder440]

I was curious to see how she could handle an 8... it pulls it but its very jumpy. After those 2 cuts in that vid I took it back to the barn to put the 7 back on. 20” 3/8 7 pin is the “just right” combination for this saw IMHO.

 

[Slumberjack]

I was curious to see how she could handle an 8... it pulls it but its very jumpy. After those 2 cuts in that vid I took it back to the barn to put the 7 back on. 20” 3/8 7 pin is the “just right” combination for this saw IMHO.

Hey but she still pulled it

 

[davidwyby]

I looked for a small spline 3/8”-8 once, seems they were kind of pricey.

 

[MustangMike]

Mason, is it me, or is that chain cutting at an angle?

 

[huskyboy]

Mason, is it me, or is that chain cutting at an angle?

I didn’t cut out in any of the cuts by the looks of it? I did try to keep the cookies pretty thin.

 

[Lightning Performance]

I didn’t cut out in any of the cuts by the looks of it? I did try to keep the cookies pretty thin.

Must be the new SliceOmatic, it slices, it dices and so much more.

 

[RI Chevy]

Mason, is it me, or is that chain cutting at an angle?

I think it's an optical illusion Mike. I asked the same question to him. These phones sometimes play games with how they capture video.

 

[MustangMike]

If you go a few tests back, you will see an eneven cookie (thicker at the bottom).