cus_deluxe
terms of service violator
- Local time
- 3:57 AM
- User ID
- 393
- Joined
- Jan 3, 2016
- Messages
- 5,605
- Reaction score
- 26,784
- Location
- Michigan
That you brandon?
Making A Walbro HDA-199 Fit On A 262XP
- Thread starter Mastermind
- Start date
Pugsley555
Well-Known OPE Member
- Local time
- 3:57 AM
- User ID
- 5641
- Joined
- Mar 18, 2018
- Messages
- 144
- Reaction score
- 73
- Location
- Fairview
Yes sir it is. Ive been trying to find a alternative to the hda-87 for the crankcand cylinder that I bought from you, I'm not sure I told you but either someone from ab site or this one offered me a 87 for $100. Iwas thinking about it but first I wanted to see if there were any other options and ran into this thread.
I'm in NC tonight but should be back home in SC by tomorrow night then I can post some pictures of the 212 hopefully by tomorrow night. Thanks again fellas
- Local time
- 2:57 AM
- User ID
- 4
- Joined
- Dec 3, 2015
- Messages
- 52,736
- Reaction score
- 351,353
- Location
- Banner Springs Tennessee
The 191, 198, or 199 will work with the mods in this thread. Some others may as well .
Pugsley555
Well-Known OPE Member
- Local time
- 3:57 AM
- User ID
- 5641
- Joined
- Mar 18, 2018
- Messages
- 144
- Reaction score
- 73
- Location
- Fairview
On the right is the hda-144 on the right is the hda-212. The port for the impulse lines up right. I just had to swap the choke rod and the plate went on fine. The 212 is a bit taller but it doesn't seem like it's gonna interfere with anything?
