Carbine
Super OPE Member
I am working on a Husky 235 for a friend, and cannot get this piece of junk to run well to save my hind end.
It probably has 5 hrs on it since new.
There appeared to be case sealant on the inside of the spark screen also, pretty impressive piece of equipment I must say.
Does anyone here have specific experience with this saw, and/or carb recommendations?
I think it's partially just a bad carb, but this guy isn't going to sink a dime in it (I wouldn't either). I'll make it the best it can be and send it back home.
I've read some on these saws, and finding a tune seems to be a common problem. I'm not sure if this saw shares most of its parts with the WT and other Poulans, but seems like some of them have an abnormal amount of turns out on the needle settings. I just tuned a PP4618 earlier this week (or something of the like), and was no issue at all.
I won't even keep it in the garage, fraid whatever it has might be contagious lol
It probably has 5 hrs on it since new.
There appeared to be case sealant on the inside of the spark screen also, pretty impressive piece of equipment I must say.
Does anyone here have specific experience with this saw, and/or carb recommendations?
I think it's partially just a bad carb, but this guy isn't going to sink a dime in it (I wouldn't either). I'll make it the best it can be and send it back home.
I've read some on these saws, and finding a tune seems to be a common problem. I'm not sure if this saw shares most of its parts with the WT and other Poulans, but seems like some of them have an abnormal amount of turns out on the needle settings. I just tuned a PP4618 earlier this week (or something of the like), and was no issue at all.
I won't even keep it in the garage, fraid whatever it has might be contagious lol