Husky t540/Walbro AT-2 metering lever height...

[PA Dan]

So I got 3 t540's on the bench that I rebuilt the carbs on. I didnt pay attention the the height of the metering lever when I took them apart. When I reassembled them two looked high and one looked low. I haven't been able to find any info online and the Walbro tool doesn't have any AT settings listed on it. Let me know if you have an idea or a carb you can take a look at. Thanks!

 

[DND 9000]

Flush with the carb body.

 

[PA Dan]

View attachment 269751
Flush with the carb body.

Thanks buddy! Back to the bench!

 

[PA Dan]

View attachment 269751
Flush with the carb body.

Do you have a link to where you found that?

 

[PA Dan]

So before I posted this thread I had called Walbro to ask about this issue. Left a message with Mike. Mike called me back today. He said the lever should be .66mm below the surface of the carb body. He said they have a new guage out that includes the AT carbs. The part number is 500-528. Time to take the carbs back off...again!

 

[huskyboy]

Did you check popoff? Just curious

 

[PA Dan]

Did you check popoff? Just curious

Nope...