Here would be your 90 degree tool: http://www.ccspecialtytoolstore.com/right-angle-rotary-hand-tool-for-porting-p/182amc.htmYa would be nice fine a nice used lathe. What’s the rule of thumb on transfers, like should 50cc saw have certain transfers numbers compared to like 70cc saw. What brand 90 degree tool do you use for the transfer.
Solid advice for this model. The 346 to me is the pinnacle of 50cc class performance, a well modified one will be the saw any man reaches for. I love mineThose numbers are great.....and is why the 346 runs so well.
Without any machine work, it's tough to improve upon it just looking at the numbers.....but.
Raise the main two transfer ports about 3°. Widen the exhaust port about a mm or so on each side. Lower to intake to 78.
Advance the flywheel about 6° and do a nice open muffler mod. I like a 3/4" id pipe for that.
They are spendy, but a must if you are wanting to do real porting on a 2-stroke.I seen those from ccspecialty . I wish there was cheaper options. But gotta pay to play lol
The only thing I would change, the next time you are grinding the divider in the lower entrance favor your knife edge so majority flow goes towards primary side upper.