First 576XP rebuild

[Larry burke]

Hey everyone, new to the OPE site. I am in the process of rebuilding my first 576XP and need the torque on the 6 crankcase bolts. Got new crank bearings in the cases and pulled the crank into the PTO side earlier. Can’t proceed to button the case up unless someone has these torque specs I desperately need.. Thanks

 

[huskihl]

I believe most guys just tighten them up to where they don’t want to go much further using a T handle.

 

[beaglebriar]

German torque spec: goodntight

 

[Dustin4185]

Hey everyone, new to the OPE site. I am in the process of rebuilding my first 576XP and need the torque on the 6 crankcase bolts. Got new crank bearings in the cases and pulled the crank into the PTO side earlier. Can’t proceed to button the case up unless someone has these torque specs I desperately need.. Thanks

Welcome. Like it has been said already, I think most just make sure they are tight. I’m sure there is a spec somewhere, but it being a mag case, I would not horse it too much.

 

[mdavlee]

I want to say it’s around 35-40 INch pounds.