Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread

[huskihl]

Personally, I’d leave the timing alone. But teach each is own.

Stock, the few I've checked I believe fired at 28° btdc. At 38 or 39° btdc they start to kick on the starter

 

[Redfin]

Which coil Kev?

 

[Mastermind]

I heard his work is similar to jms!
did I go to far?

He was my hero. Taught me everything I know.

 

[huskihl]

Which coil Kev?

Red 7900 or 64xx coil

 

[GCJenks204]

I heard his work is similar to jms!
did I go to far?

Nope, you're correct lol

He was my hero. Taught me everything I know.

Randy, turn around and let me pull that knife from your back.

If I keep ready this thread you boys are going to make me do something silly.

 

[Mastermind]

Randy, turn around and let me pull that knife from your back.

It's ok. I've gotten used to that stabbed in the back feeling.

 

[Adirondackstihl]

I heard his work is similar to jms!
did I go to far?

You might wanna find another forum to chill out at....

 

[GCJenks204]

Some how much is the 80cc top end kit?

 

[Miller Mod Saws]

Conversation starter.

 

[huskyboy]

View attachment 136394 Conversation starter.

Stuff it in a smurf 6400 and leave the low top and tell everyone at a gtg it’s a 60 cc saw. Sleeper. lol

 

[Roadfxr]

Some how much is the 80cc top end kit?

Might as well just do it Gary. You won’t regret it. I had the Solo hybrid out the other day and damn I love that saw...

 

[huskyboy]

I ended up the “birdcage” completely today. Seems to run a little cooler and performance is impressive. I want to discuss air filters on these saws next. I’ve heard that the high top restricts them... but it is supposed to stay clean longer. I’ve never felt the standard setup on mine was inferior so far in the limited experience I’ve had, it stays fairly clean in dusty conditions. I do want to try a mesh filter and see if it gains more. I’m running a flocked right now.

 

[T.Roller]

I had to put grease around the base of the neck to keep fines out. It pulled them in bad

 

[T.Roller]

421 is the same way

 

[Backtroller]

I really like the mesh. I had the HD set up and sold it. @mdavlee had some video of mine with and without. I believe it’s the elbow in the HD set up that is the bottle neck.

 

[huskyboy]

Grease is definitely a must on plastic to plastic sealing surfaces on the air filters in any saw i noticed imho. The problem seems to go away after you do that.

 

[huskyboy]

I really like the mesh. I had the HD set up and sold it. @mdavlee had some video of mine with and without. I believe it’s the elbow in the HD set up that is the bottle neck. View attachment 136398View attachment 136399

What’s the part # on that? I might try it.

 

[T.Roller]

Grease is definitely a must on plastic to plastic sealing surfaces on the air filters in any saw i noticed imho. The problem seems to go away after you do that.

I agree 100%

 

[T.Roller]

What’s the part # on that? I might try it.

Yeah I want one too

 

[Mastermind]

Like pulling out your pecker in a hoe house.