Clint's P60

[Bigmac]

Does your saw need something yet to be able to run? I don't have any Pioneer stuffs, but maybe we can find what it needs, if that's all it is.

I remember something about a compression release

 

[p61 western]

I remember something about a compression release

If that's it have one Clint can have. Probably other stuff as well.

 

[Frank bierce]

Does your saw need something yet to be able to run? I don't have any Pioneer stuffs, but maybe we can find what it needs, if that's all it is.

Jim says, when the cylinder was blasted and cleaned up, the decomp threads were blasted away, and now the decomp will not hold properly.

 

[Stump Shot]

Jim says, when the cylinder was blasted and cleaned up, the decomp threads were blasted away, and now the decomp will not hold properly.

So it needs a new cylinder then?

 

[jacob j.]

So it needs a new cylinder then?

The threads could likely be repaired - with either a heli-coil/time-sert, or a larger compression release could be fitted.

 

[Frank bierce]

So it needs a new cylinder then?

Either a cylinder, or a timesert kit to fix the hole. As far as I’m concerned...whatever shape the saw is in...if Clint wants it back, he should have it back.

 

[sawfun]

I doubt if Jim owns a drill. He had very few tools when I was dealing with him. And a Helicoil or Time Sert might just be advanced rocket science to him.

 

[jacob j.]

Either a cylinder, or a timesert kit to fix the hole. As far as I’m concerned...whatever shape the saw is in...if Clint wants it back, he should have it back.

I doubt it needs a cylinder. The long compression release from a 3120K would probably work fine - the base on those is larger than the SAE compression releases that come on the Pioneers.

The hole would have to be threaded for the metric 3120k release. I think the threads are m8 x 1.5.

 

[Stump Shot]

I doubt it needs a cylinder. The long compression release from a 3120K would probably work fine - the base on those is larger than the SAE compression releases that come on the Pioneers.

The hole would have to be threaded for the metric 3120k release. I think the threads are m8 x 1.5.

If that will work, I have a new long decompression valve here.
Standard thread like other decomps

 

[srcarr52]

Since the decomps are such a tiny pitch at 10mm x 1.0 an installed heli-coil's hole isn't bigger than the standard crush washer that comes on them.

 

[Mastermind]

Jim says, when the cylinder was blasted and cleaned up, the decomp threads were blasted away, and now the decomp will not hold properly.

Well.....he said that, then he said it wasn't a problem, then he said it was.......

Jim is a few french fries short of a happy meal if you ask me.

 

[huskihl]

McDonald’s has the best fries

 

[Czed]

McDonald’s has the best fries

DQ

 

[Fruecrue]

Bump.

 

[Mastermind]

McDonald’s has the best fries

Agreed.

DQ

My wife would agree with you.

 

[Mastermind]

Well Chit !!!

 

[Mastermind]

Bump.

 

[Mastermind]

Chit again !!!!

 

[P.M.P.]

 

[Fruecrue]

Chit again !!!!

You suck.