- Local time
- 2:05 AM
- User ID
- 522
- Joined
- Jan 12, 2016
- Messages
- 3,970
- Reaction score
- 26,133
- Location
- Iowa City
I thought of this project in May of 2014 when building a lot of 394's. I had bought an NWP 395BB top end to go on a 395 builder carcass and thought why not make it a stroker too. So I bought a 2100 crankshaft and started to look at what machining needed to be done.
Flywheel side of crank needs machined to fit 395 flywheel.
Cases needs some clearancing.
Then life got busy and the project went to rot in a box. Said box was moved from the garage of my old house into the basement of the new house were it rotted in climate control for 2 years... until a few weeks ago.
Flywheel side of crank needs machined to fit 395 flywheel.
Cases needs some clearancing.
Then life got busy and the project went to rot in a box. Said box was moved from the garage of my old house into the basement of the new house were it rotted in climate control for 2 years... until a few weeks ago.