880 toy

[Stihl working Hard]

Nothing more done besides linkage. Waiting on the pipe to get here. I hope to get on it next weekend.

I hope your not teasing us this thread has me captivated

 

[mdavlee]

I hope your not teasing us this thread has me captivated

I'll have video when I get the pipe on and tune it. Got a 25" roller nose bar and need to get the chain ready.

 

[Time's Standing Stihl]

Did you order a pipe Mike or custom built?

 

[mdavlee]

Did you order a pipe Mike or custom built?

Adam found the one he built for the cylinder. He's sending it to me.

 

[Adirondackstihl]

 

[mdavlee]

I hope Friday to have it together and try to tune it.

 

[Time's Standing Stihl]

Adam found the one he built for the cylinder. He's sending it to me.

Them Minnesota boys sure can build a mean saw

 

[mdavlee]

Them Minnesota boys sure can build a mean saw

This was Adam from California

 

[Adirondackstihl]

This was Adam from California

Senor Clarke

 

[czar800]

Great build

 

[Lightning Performance]

Nice!
So, when will you be killing Godzilla? Soon?

 

[mdavlee]

Tomorrow if everything goes good

 

[Stihl working Hard]

Waiting patiently here

 

[spencerpaving]

It's friday....

 

[T.Roller]

 

[mdavlee]

Well carb problems. The H screw won't stay still. It run good for a half cut and then it closes off. I'm going to break down and order a WB3 that has Springs on the H screw.

 

[T.Roller]

Boooo

 

[spencerpaving]

Well carb problems. The H screw won't stay still. It run good for a half cut and then it closes off. I'm going to break down and order a WB3 that has Springs on the H screw.

Stuff a o-ring in there. ...might help hold it

 

[mdavlee]

Stuff a o-ring in there. ...might help hold it

I would but one stripped the hole. The tank was against it too hard. If I have time I may try to fit a 084 carb on there. Same pattern just be rolled some.

 

[Locust Cutter]

Subbed...