2260 bearing fail

[Dub11]

I use heat to seat bearings in the case. Should I not be doing this??? I’ve never seen mag shavings after an assembly but if there’s a better way I’m all ears.

Yes heat like Joe said. That's the way we doing it at work and them bearings cost more than these saws lol.

 

[Tor R]

I use heat to seat bearings in the case. Should I not be doing this??? I’ve never seen mag shavings after an assembly but if there’s a better way I’m all ears.

heat is our friend, continue to heat up the case before you slide in them bearings and you will be fine.

This cold pressing technique is something Husky do, I woudnt recommend it at all, the number waranty's they has due blown bearings & cranks is probleby good enough reason to unvoid cold pressing.

 

[XP_Slinger]

Copy all, thanks gents. I think I mis-read Tor’s original post. My fault not his

 

[Dub11]

Bearing

 

[XP_Slinger]

Bearing View attachment 121384

Wow, they did beef up the bearings in the 572 didn’t they

 

[Dub11]

Wow, they did beef up the bearings in the 572 didn’t they

That's for the 5120...

 

[Onan18]

Bearing View attachment 121384

You call that a bearing? Pppppppppfffffffffffffffffffffffffffftttttttttttttttttt!!!!!!!!!!

 

[Dub11]

You call that a bearing? Pppppppppfffffffffffffffffffffffffffftttttttttttttttttt!!!!!!!!!!

We are only a small time shop.

 

[rattler]

 

[Tpagel]

I can't wait to get it back Mike.
I think it will be sweet

Sent from my SM-J327V using Tapatalk

 

[dustinwilt68]

Best 1.00 I spent was for my toaster oven at. Auction

 

[tree monkey]

tits a husky thang

 

[tree monkey]

 

[XP_Slinger]

Holy Feck! WTF is that for?? Prop shaft on an aircraft carrier??

 

[RI Chevy]

Looks like its fits an output shaft for a cruise ship. Lol

 

[Johnmn]

Is this a 5 or 6 bolt case? Or is that not the issue here? Has the underlying issue always been cold pressing?

 

[stihl_head1982]

View attachment 121282 View attachment 121283

Me likey this crank case tool. Did you make that sir?

 

[rattler]

Is this a 5 or 6 bolt case? Or is that not the issue here? Has the underlying issue always been cold pressing?

This is a 6 bolt case John

 

[rattler]

Me likey this crank case tool. Did you make that sir?

A good Friend sent that to me

 

[rattler]