2159 Round 2

[Stump Shot]

Thanks Steve! And porting wise, I’m trying to go for power everywhere. Don’t want it to be too peaky, not too lowendy (don’t even know if thats a word).

What's your exhaust number?

 

[David Young]

Intake makes em drink...80 is probably good

 

[David Young]

View attachment 282662 View attachment 282663 View attachment 282664 Here is the cylinder I am going to run. Still have to sand a little bit more off of the JB weld to make it sit flat.

What are you hitting on. You shouldn’t need to grind anymore.

 

[ZukiRyder440]

What are you hitting on. You shouldn’t need to grind anymore.

Your right! The gasket will probably seal that up just fine

 

[ZukiRyder440]

What's your exhaust number?

Aiming for 103*-104*

 

[Stump Shot]

Aiming for 103*-104*

Shoot for 79 to 78 degrees on the intake respectively.

 

[ZukiRyder440]

Shoot for 79 to 78 degrees on the intake respectively.

Will do.

 

[ZukiRyder440]

Thanks for the tips Steve. Really appreciate it

 

[Stump Shot]

Thanks for the tips Steve. Really appreciate it

 

[ZukiRyder440]

Thanks

 

[ZukiRyder440]

Mufkin mod. There is a HUGE hole under that deflector. She sounds nice

 

[ZukiRyder440]

Still has the Meteor 357 top end on it in this video. This video was taken in March of 2020.

 

[ZukiRyder440]

Got some lower work done today. Tried my best to get them to look alike

 

[ZukiRyder440]

Also, this new Dremel I bought yesterday is freakin awesome. Cant push on it as hard as a normal dremel but it gets the job done. I believe it was $45.

 

[ZukiRyder440]

Welp so much for little lower transfer work.. lol! The work I did before might have helped a teensy bit but not much. Muh dad said to get rid of that hump and smooth out the lip on the transfer on the bottom without compromising too much of the sealing surface. AND still waiting for the piston...

 

[old guy]

Sharpen the end of that divider up in there but don't grind them out.

 

[ZukiRyder440]

Looky what I got today.

 

[ZukiRyder440]

New piston installed

 

[ZukiRyder440]

Heres what the cylinder came in at with the base/band cut (On bottom). Left the intake alone, raised the transfers and exhaust and widened it to about 65% of Bore (32.53mm). Forgot to get pictures of the uppers .

 

[ZukiRyder440]

Squish with a thinner base gasket: