Wilhelm's latest activity
-
Wilhelm replied to the thread The Metalworking Thread.I worked a 19mm CR-V allen wrench piece today. Milling the end flat with a Solid-Carbide 10mm end mill, and drilling the hole with a... -
-
These are what I got. They worked beautifully drilling holes through 1/4in plate yesterday...
-
Brussel sprouts and honey should also help with your gas supply...
-
There is a caboose on display in a park near one of the county offices that my job serves, it is unusual on two counts. The build date...
-
Getting it past the wife would require some careful planning...
-
Check this out. On Monday, an ex-C&O caboose wearing original colors was being used on a revenue train in Lexington, KY. Even though the...
-
Philbert
-
-
-
New bars in the 2388. Beans aren’t very good up here this year. See small beans. Northern lights Peice of soybean stubble stuck...
-
I got it stuck bad multiple times and had to kick it out. Didn’t break or work loose 🤙🏻
-
It is definitely worth the trip!! I was able to make it back in August, but it was a whirlwind trip from Idaho to Indiana and back, but...
-
Meanwhile, I have been adding a few more saws for the display. Wright 141 to compliment the Dayton 2Z462A already in the display...
-
Been a while since I updated this thread, I've been very busy and work on the new building has been progressing. Siding is on the front...
-
To get this thread back on track, all those pitch and gauge tools work on standard chain, PowerSharp chain, square ground chain...
