Saw video thread

[ferris]

@Redbull661 can you Upload your 660 video ( without muffler mod vs with muffler mod) again?

 

[Onan18]

Joe said they were bottom fed quad port

SRM-265T engine.

New short block and a muffler mod.

 

[drf256]

This one needs the ignition timing dialed back a bit. Bit me bad and popping.

 

[RI Chevy]

Very nice! Looks and sounds like a ripper!

 

[ranchdadmike]

This one needs the ignition timing dialed back a bit. Bit me bad and popping.

Thing of beauty. Thanks Doc!

 

[RI Chevy]

That is a nice saw Mike! [emoji106]

 

[smokey7]

Ii heard very little popping. Maybe just a tiny bit. Are you going to back it off a couple degrees? That saw had it all to me... It had awesome throttle response very nice overrev and strong lugging ability. Very nice saw and sounded very free and in sync.

 

[TreeLife]

I wouldn't change a thing. If it's popping it's seldom and lightly, that saw runs GOOD doc. Wouldn't change it at all

 

[Fruecrue]

Chinese MS440, New west big bore.
Timed it at 103/120/64 without base gasket,
Squish at .016”.
Running in video with .020” gasket.
Definitely needs more intake.
Band is good and wide, compression feels stout.
There’s potential here for sure.
Going to come apart for porting after some run time.

 

[huskyboy]

Chinese MS440, New west big bore.
Timed it at 103/120/64 without base gasket,
Squish at .016”.
Running in video with .020” gasket.
Definitely needs more intake.
Band is good and wide, compression feels stout.
There’s potential here for sure.
Going to come apart for porting after some run time.

Wow that thing really is a pooch. I’m interested in the after video. Bet it gains like 50%. Lol

 

[maulhead]

Wow that thing really is a pooch. I’m interested in the after video. Bet it gains like 50%. Lol

 

[Fruecrue]

Intake timing alone should really free it up.

 

[Fruecrue]

More intake, a lot more, only change.

 

[Canadian farm boy]

More intake, a lot more, only change.

Way more gooder.

 

[huskyboy]

More intake, a lot more, only change.

Completely different saw.

 

[TreeLife]

I likes it moar now

 

[T.Roller]

Chinese MS440, New west big bore.
Timed it at 103/120/64 without base gasket,
Squish at .016”.
Running in video with .020” gasket.
Definitely needs more intake.
Band is good and wide, compression feels stout.
There’s potential here for sure.
Going to come apart for porting after some run time.

What a turd lol

 

[T.Roller]

More intake, a lot more, only change.

Way more better

 

[Fruecrue]

 

[RI Chevy]

WTF. They look like Taliban.
All fun and games until someone looses a foot.