Poor mans porting tools ... vid...

[Mattyo]

Jason....I agree with you wholeheartedly. ...and it's the reason you have my saws. You do prettier grinding than I do....period. ...and in due course...that's the same conclusion the guys that do "poor man's porting" will come to as well. It gives you an appreciation for those that do grinding...and do it well.

 

[Mattyo]

Poor man's ported 394xp. Case decked on bridgeport after I sanded squish band....

.021 squish with gasket 185 comp.

101 121 80

No grinding on uppers ....no need because the timing was good without it.

She runs just fine with a 32

 

[Dub11]

Poor man's ported 394xp. Case decked on bridgeport after I sanded squish band....

.021 squish with gasket 185 comp.

101 121 80

No grinding on uppers ....no need because the timing was good without it.

She runs just fine with a 32

NICE! I have access to a Bridgeport at work ! How is that cheap dental right angle tool holding up?

 

[Mattyo]

The main tool is fine...the angle heads wear out ...I get about 1 set of uppers out of a head...and at 9$ each...that's not too bad. Didn't need to use the angle head on the 394 ....

But this one....660...for sure:

 

[Dolkitafreak]

These air powered mini grinders you can turn the speed up and down by turning the black plastic band ,ran one for a bit so far ,did not ice up on me at all .Got bit kits also ,a snap on one and a dremil one ,tool truck had them on the truck .View attachment 63218 View attachment 63219 View attachment 63220

Any update on this handpiece? I may have to give one a try!