SELLING Or trade 281 KS cylinder misc 288 parts

[cornykid]

I bought a project saw 288. It has donor parts from three different saws. Anything in the pictures is available. I am looking for a good tank, the impossible high top, and 28-32" lightweight bar. Pics will be posted separate.

 

[cornykid]

This is what I have, plus two oil pumps

 

[cornykid]

This is a 281 cylinder and piston, I'll check the mahle cylinder on the short block also.


Might be a 281, I'll measure

 

[cornykid]

 

[cornykid]

Not sure on the flywheels, maybe one is for a heated handle generator, or for a different saw.

 

[klipweld]

Pm sent

 

[cornykid]

Both top covers,both front av mounts, air conductor, and muffler support are spoken for. Thanks

Sent from my XT1710-02 using Tapatalk

 

[timg]

Does the carburetor have a roller link or conventional link rod set up on the throttle shaft?? Hard to tell by your picture. Thanks TG

 

[cornykid]

It has the roller linkage.


Sent from my XT1710-02 using Tapatalk

 

[timg]

PM me a price

 

[huskyboy]

I could be wrong but looks like the fuel elbow is broke off on the carb

 

[cornykid]

I do believe that you are right. Thanks for the heads up.

Sent from my XT1710-02 using Tapatalk

 

[cornykid]

The heated handle flywheel is spoken for pending funds. I did measure the cylinder on the short block, and it is a 288. Thanks for all the interest. I'm also looking for a loop of square ground chain on trade.

Sent from my XT1710-02 using Tapatalk

 

[mikerudder]

What are you looking to get for the 288 case?

 

[cornykid]

It's looking like everything is spoken for. Thanks to all. I'm still looking for a good tank, 28-32" bar, and any square ground chain 3/8, 058 in 68,72,84 DL.

Sent from my XT1710-02 using Tapatalk